Motorola Radius CM300 설치 매뉴얼 - 페이지 26
{카테고리_이름} Motorola Radius CM300에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Motorola Radius CM300 36 페이지. Commercial series
페이지 인쇄
18
Chapter 8
Operation of a Conventional Ignition System
8.1
Introduction
To effectively reduce ignition interference in a vehicle, it is necessary to understand the operation of
an automobile ignition system.
Ignition is necessary in a gasoline engine to ignite the gasoline vapor and the air mixture in its
cylinders. The system is made up of the battery, distributor, breaker points, coil, condenser, and spark
plugs. The battery is the only electrical source of power in an automobile, so the lower battery voltage
must be stepped up to the high voltage necessary to arc across the spark plug electrodes. This arc
ignites the gas mixture.
8.2
Sources of Ignition Interference
In the conventional ignition system (Figure 8-1) a mechanical circuit breaker (the cam and points in
the distributor) opens the primary circuit of the ignition coil, and high voltage is developed at the
secondary. This high voltage is synchronized and applied to each spark plug by the distributor.
Ignition
Switch
Battery
Ignition
Switch
Battery
Figure 8-1. Typical Vehicular Ignition System, Simplified Schematic Diagram
Breaker
Points
Cam
Condenser
Breaker
Points
Cam
Condenser
HV Lead
Ignition
Coil
Rotor Gap
Ignition
Coil
Stray
Capacitance
Distributor
Spark plug
leads
Spark
Plugs
Lead Inductance
Spark Plug Gap
FL0830261-O