Motorola Radius PM400 설치 매뉴얼 - 페이지 27

{카테고리_이름} Motorola Radius PM400에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Motorola Radius PM400 36 페이지. Commercial series
Motorola Radius PM400에 대해서도 마찬가지입니다: 브로셔 및 사양 (15 페이지)

페이지 인쇄

Operation of a Conventional Ignition System

The battery is connected to the primary winding of the coil through the ignition switch. The primary

circuit is returned to the battery through the breaker points, which are bypassed by the condenser.

The points are normally closed. As the cam shaft is rotated by the engine, it's lobes or corners open

and close the points in proper synchronization with the piston in each cylinder.

With the ignition switch on and the breaker points closed, coil primary current builds up at a rate

determined by the coil inductance.

When the breaker points open, primary current decreases and, by self-induction, an electromotive

force is induced in the primary which is many times greater than the battery voltage. The high voltage

inducted in the coil secondary causes a spark across the distributor rotor-to-spark plug wire gap and

then across the spark plug gap for a short interval of time when the breaker points open. The

condenser reduces arcing of the points.

The secondary circuit of the ignition coil, including the distributor rotor gap and the spark gap, is the

main source of ignition interference. The lead inductance and stray capacitance provide a tuned

circuit. Because the discharge of the circuit is through a low resistance (ionized spark gap), the circuit

tends to oscillate. The frequency and amplitude of oscillation vary as current changes in the spark

gap.