Motorola Spectra SmartNet C4 매뉴얼 - 페이지 6
{카테고리_이름} Motorola Spectra SmartNet C4에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Motorola Spectra SmartNet C4 38 페이지. Radio system
Motorola Spectra SmartNet C4에 대해서도 마찬가지입니다: 사용 설명서 (46 페이지)
1. Getting started
WARNING
Do not place your C4 in the bathroom or other humid areas.
Location
You need to place your C4 base within 2 metres of the mains
power and telephone wall sockets so that the cables will
reach. The socket-outlet shall be installed near the
equipment and shall be easily accessible.
Make sure that it is at least 1 metre away from other
electrical appliances to avoid interference. Your C4 works by
sending radio signals between the handset and base. The
strength of the signal depends on where you place the base.
Placing it as high as possible ensures the best signal.
HANDSET RANGE
The unit has a range of up to 300 metres outdoors when there
is a clear line of sight between the base and handset. Any
obstruction between the base and handset will reduce the
range significantly. With the base indoors and the handset
either indoors or outdoors, the range will normally be up to 50
metres. Thick concrete walls can severely affect the range.
SIGNAL STRENGTH
The
icon on your handset indicates that you are within
range of the base. When out of range of the base, the
icon flashes. If you are on a call, you will hear a warning
beep.
6
The line will hang up if the handset moves out of range of the
base. Move closer to the base. The handset will
automatically reconnect to the base.
Setting up
IMPORTANT
The base station must be plugged into the mains power at all
times. Do not connect the telephone line cord into the wall
socket until the handset is fully charged. Use only the power
adaptor and telephone line cord supplied with the product.
WHICH POWER ADAPTOR?
The power adaptor with a clear connecter is for the base unit
and the power adaptor with a red colour connecter is for the
charger unit (for multi-pack only).
Connecting the base
1. Plug the telephone line cord into the socket marked
on the underside of the base.
Getting started