Motorola TALKABOUT T5500 사용자 설명서 - 페이지 7

{카테고리_이름} Motorola TALKABOUT T5500에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Motorola TALKABOUT T5500 17 페이지. Frs/gmrs recreational two-way radios
Motorola TALKABOUT T5500에 대해서도 마찬가지입니다: 사용자 설명서 (36 페이지), 커뮤니케이션 매뉴얼 (16 페이지), 사용자 설명서 (5 페이지)

페이지 인쇄
Motorola TALKABOUT T5500 사용자 설명서
T5000 & T5500 user guide --- Pg 13

Getting Started

Installing the AA Batteries
Your radio uses 3 AA Alkaline batteries.
1.
With the back of the radio facing you, lift the battery latch
up to release the battery cover and remove the cover.
2.
Insert 3 AA Alkaline batteries as shown on the inside of the
battery compartment.
3.
Reposition the battery cover and press down to secure.
Note: The T5000,T5500 and T5550 model radios can use a NiCd
rechargeable battery instead of 3 AA Alkaline batteries.
A rechargeable battery upgrade kit, is available for these
radios.

Installing the NiCd Battery Pack

Follow step 1 above to remove the battery cover.
1.
Remove the battery pack from the clear plastic bag.
2.
Do not disassemble or unwrap the battery pack.
3.
Insert the NiCd battery pack so the matel contacts on
the side of the battery are facing outward from the radio
to connect with the contacts on the battery door.
4.
Reposition the battery cover and press down to secure.
T5000 & T5500 user guide --- Pg 14

Battery Meter

The battery icon shows the battery charge level, from full
the battery is empty, the radio chirps periodically after releasing
off when the voltage drops below a predetermined level to protect the rechargeable
battery.
Note: Remove the batteries before storing your radio for extended periods of time.
Batteries corrode over time and may cause permanent damage to your radio.
Using the Desk Stand Charger (Optional Accessory)
The desk stand charger provides drop-in charging convenience for NiCd batteries and
can be placed on any flat surface, such as a desk or workbench. Charge the NiCd battery
overnight (at least 16 hours) before using it for the first time. After the initial charge,
an empty battery is fully charged within 14 hours.
1.
Turn the radio off and remove the battery cover.
2.
Remove the battery pack from the clear plastic bag.
Do not disassemble or unwrap the battery pack.
3.
Insert the NiCd battery pack so the metal contacts on the side of the battery are
facing outward from the radio to connect with the contacts on the battery door.
4.
Reposition the battery cover and press down to secure.
5.
Plug the AC power supply into the plug on the desk stand.
6.
Plug the AC power supply into a standard wall outlet.
7.
Slide the radio into one of the charging pockets facing forward.
14
13
to empty
. When
. The radio powers