Motorola XPR 4300 설치 매뉴얼 - 페이지 29

{카테고리_이름} Motorola XPR 4300에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Motorola XPR 4300 45 페이지.

Chapter 3 Options and Accessories Installation

3.1

Emergency Pushbutton, Footswitch, Horn Relay, and Light Relay

Installation

Perform the following installation procedure:

1. Select an appropriate place to mount the option or accessory hardware.

2. Route the accessory-to-control head cables under floor coverings or behind panels so that

the vehicle occupants do not snag or break the wires.

3. Attach wires from the accessory to the appropriate wire on the VIP cable. (see

Table

3-2).

extraction tool to remove wires.

3.1.1

Mount the switch using the hardware that comes with the kit. Connect the emergency switch wires to

a ground pin and a VIP IN pin on the VIP connector.

3.1.2

Mount the horn relay in a suitable location (normally under the dash). Connect the relay contacts

across the horn ring switch, typically found in the steering column. Connect the two control wires to a

SW B+ pin and a VIP OUT pin on the VIP connector.

3.1.3

Mount the light relay in a suitable location (normally under the dash). Connect the relay contacts

across the headlamp ON/OFF switch. Connect the two control wires to a SW B+ pin and a VIP OUT

pin on the VIP connector.

3.2

For dash-mounted configurations, the accessories must be installed through the accessory

connector assembly that is located on the rear of the radio, adjacent to the power connector.

Motorola-approved accessories are supplied with male terminals crimped to a 20-gauge wire

specifically designed to fit the plug of the accessory connector assembly.

Figure 3-1

shows how wires are plugged into the connector and how to use an

Table 3-1

and