Motorola XPR 4350 설치 매뉴얼 - 페이지 28

{카테고리_이름} Motorola XPR 4350에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Motorola XPR 4350 45 페이지.

2-12

2.7

Microphone Hang-Up Clip

2.7.1

The hang-up clip must be within reach of the operator(s). Measure this distance before actually

mounting the bracket. Since the bracket has a positive-detent action, the microphone can be

mounted in any position. The microphone hang-up clip must be grounded.

Use the hang-up clip as a template to locate the mounting holes. To avoid interference when

removing the microphone, install the flathead screw in the top clip hole.

2.7.2

Use the hang-up box (HUB) as a template to locate the mounting holes. Be sure the HUB will be

within easy reach of the operator. Route the control wire with the male pin to the accessory cable

connector at the rear of the radio or cable harness as shown in

cable connector and connect the HUB control wire to location 3 of the accessory connector. Connect

the other control wire from the HUB to a convenient solid chassis ground point.

2.8

Complete the installation by connecting the speaker and power wires and plugging in the

microphone cable/handheld control unit. Be sure to connect the microphone S-hook to the holes in

the trunnion provided (see

March 23, 2006

Figure

2-7) for strain relief (this is not applicable for 110W radios).

Standard Configurations: Microphone Hang-Up Clip

Figure

2-3. Open the accessory

6816812H01