Motorola CLP series 사용자 설명서 - 페이지 31
{카테고리_이름} Motorola CLP series에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Motorola CLP series 48 페이지. By wsi
Motorola CLP series에 대해서도 마찬가지입니다: 빠른 참조 매뉴얼 (2 페이지), 빠른 참조 (2 페이지), 빠른 참조 (35 페이지), 문제 해결 매뉴얼 (2 페이지)
페이지 인쇄
Chapter 5
Radio Cloning
This feature allows you to clone radio settings from one radio to another.
5.1
Cloning Radio Settings
You can copy the radio settings from the source to another radio.
You can use one of the following unit chargers and cables for cloning:
•
CLP Series Single Unit Charger (SUC) kit part number HKPN4008_ and CLP Series Cloning Cable
kit part number HKKN4026_ (optional accessory).
•
Multi-Unit Charger (MUC) Kit Part Number HKPN4007_ (optional accessory)
A multi-channel radio can be cloned to a single channel radio but only the first channel is cloned. The
MUC does not have to be plugged in for cloning, but both radios require charged batteries.
NOTE: The enhanced CLP software also uses the LED to indicate pass or fail status during
cloning. Green LED during cloning indicates pass status and red LED during cloning indicates
fail status.
5.2
Cloning Radios using the Cloning Cable
Prerequisites: Cloning radios using Multi-Unit Charger (MUC) kit part number HKKN4026_ (optional
accessory)
•
A fully charged battery on each radio.
•
Two Single-Unit Charger (SUC) Kits.
•
Both radios are turned off.
•
Source radio: Radio to be cloned.
•
Target radio: Radio to which the configuration of the source radio is to be copied.
Figure 12: Cloning the Radio through a Single Unit Charger
Procedure:
1 Unplug any cables such as power supply or micro USB cables from the SUC.
68012000044-ED
Radio Cloning
31