Motorola CP040 자세한 서비스 매뉴얼 - 페이지 26
{카테고리_이름} Motorola CP040에 대한 자세한 서비스 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Motorola CP040 28 페이지. Commercial radios uhf1
Motorola CP040에 대해서도 마찬가지입니다: 서비스 정보 (48 페이지), 서비스 정보 (46 페이지), 사용자 설명서 (18 페이지), 서비스 정보 (30 페이지)
페이지 인쇄
2-6
Circuit Block Interconnection Legend:
7.
USWB+
5V
5R
5T
RESET
D3_3V
3V
TX_ENA
PWR_SET
DEMOD
BW_SEL
RSSI
IF_IN/OUT
RF_IN/OUT
MOD OUT/IN
16_8_MHZ
SYNTH_CS
SPI_CLK
SPI_DATA_OUT
LOCK
PRESC
V_STEER
V_SF
VCO_MOD
TRB
RX_INJ
TX_INJ
Name
Unswitched Battery Voltage (always on)
5 volts (regulated)
5 volts in RX mode only
5 volts in TX mode only
Low-line reset signal from U320 to uP
Digital 3.3 volts (regulated)
Analog 3 volts (regulated)
Transmit enable signal from uP to transmitter
DC voltage from ASFIC to TX power control
RX audio from backend to ASFIC
Backend filter BW select from ASFIC
RX signal strength indication from IFIC to uP
44.85 MHz from 1st mixer to high IF filter
RX signal from antenna switch to front end
TX modulation from ASFIC to synthesizer
Ref osc signal from synthesizer to ASFIC
Synthesizer chip select from uP
Serial clock from uP
Serial data from uP
Lock detect indication from synth to uP
VCO freq feedback from VCOBIC to synth
Steering line voltage from synth to VCO's
Super-filtered 4.5 volts from synth to VCOBIC
TX modulation from ASFIC to synthesizer
TX/RX control from synth to VCOBIC
Buffered RX VCO output to RX 1st mixer
TX VCO output to transmitter input
Description
MAINTENANCE