Motorola CP180 자세한 서비스 매뉴얼 - 페이지 22

{카테고리_이름} Motorola CP180에 대한 자세한 서비스 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Motorola CP180 28 페이지. Uhf2 (438-470mhz)
Motorola CP180에 대해서도 마찬가지입니다: 기본 사용 설명서 (16 페이지), 기본 사용 설명서 (16 페이지), 기본 사용 설명서 (18 페이지), Cps/튜너 설치 매뉴얼 (6 페이지), 서비스 정보 (46 페이지), 서비스 정보 (46 페이지)

2-2

Always use a fresh supply of alcohol and a clean container to prevent contamination by

NOTE

dissolved material (from previous usage).

3.0

Safe Handling of CMOS and LDMOS

Complementary metal-oxide semiconductor (CMOS) devices are used in this family of radios.

CMOS characteristics make them susceptible to damage by electrostatic or high voltage

charges. Damage can be latent, resulting in failures occurring weeks or months later. Therefore,

special precautions must be taken to prevent device damage during disassembly,

troubleshooting, and repair.

Handling precautions are mandatory for CMOS circuits and are especially important in low

humidity conditions. DO NOT attempt to disassemble the radio without first referring to the CMOS

CAUTION paragraph in the Disassembly and Reassembly section of the manual.

4.0

IC Pre-Baking

No pre-baking of components is required in the repair of this product.

Parts Replacement and Substitution

When damaged parts are replaced, identical parts should be used. If the identical replacement

component is not locally available, check the parts list for the proper Motorola part number and

order the component from the nearest Motorola Communications parts center listed in the "Piece

Parts" section of this manual.

Rigid Circuit Boards

The family of radios uses bonded, multi-layer, printed circuit boards. Since the inner layers are

not accessible, some special considerations are required when soldering and unsoldering

components. The through-plated holes may interconnect multiple layers of the printed circuit.

Therefore, care should be exercised to avoid pulling the plated circuit out of the hole.

When soldering near the 18-pin and 40-pin connectors:

avoid accidentally getting solder in the connector.

be careful not to form solder bridges between the connector pins

closely examine your work for shorts due to solder bridges.

MAINTENANCE