Motorola GP1280 Series 기본 서비스 매뉴얼 - 페이지 45
{카테고리_이름} Motorola GP1280 Series에 대한 기본 서비스 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Motorola GP1280 Series 46 페이지. Professional radio, power distribution and controller
Motorola GP1280 Series에 대해서도 마찬가지입니다: 서비스 정보 (32 페이지), 서비스 정보 (30 페이지), 서비스 정보 (30 페이지)
페이지 인쇄
1.0
Error Codes
Turning on the radio starts a self-test routine that checks the radio functionality. If the checks are
successful, the radio generates two high-pitched self-test pass tones, or a musical tone (selected in
CPS). If the self-test is not successful, one low-pitched tone is heard. Radios with displays are able
to display the error codes. The displayed error codes and related corrections are listed in Table 7-1.
If the error code
displayed is...
"Chan Spacing"
"EEPROM Cksum"
"Synth Lock"
"RF Config"
"RAM Test"
"Personality D"
"Dynamic CP"
"Flash Cksum"
"Hardware Test"
No Display
300Hz Tone
(Radio Without Display)
Table 7-1 Power Up Error Codes
then, there is a...
Invalid channel spacing.
Codeplug structure mismatch or
non-existence of codeplug.
Channel frequency invalid for radio
model.
Channel frequency outside allowed
range or invalid channel number for
channel frequency plan.
RAM test failure
Personality data invalid
Dynamic codeplug failure.
Radio EPROM failure.
Radio hardware failure.
Display module is not connected.
Display module faulty.
Radio hardware failure or invalid
codeplug.
POWER UP SELF-TEST
To correct the problem...
Reprogram codeplug with correct spacings.
Reprogram codeplug with correct version
and retest radio.
If message reoccurs, replace main board or
return it to the nearest Motorola depot.
Reprogram codeplug with correct
frequency and channel range.
Reprogram codeplug with valid
frequencies/channels.
Turn radio off-on.
If message reoccurs replace main board or
return it to the nearest Motorola depot.
Reprogram codeplug with valid personality.
Turn radio off then on.
If message reoccurs replace main board or
return it to the nearest Motorola depot.
Turn radio off then on.
If message reoccurs replace main board or
return it to the nearest Motorola depot.
Turn radio off-on.
If message reoccurs replace main board or
return it to the nearest Motorola depot.
Check connection between main board and
the display module.
Replace display module.
Turn radio off then on.
If tone still sounds reprogram codeplug and
retest. If tone continues to sound replace
the main board or return it to the nearest
Motorola depot.
Chapter 7