Epson LABELWORKS PX 운영자 매뉴얼 - 페이지 9
{카테고리_이름} Epson LABELWORKS PX에 대한 운영자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Epson LABELWORKS PX 14 페이지.
Epson LABELWORKS PX에 대해서도 마찬가지입니다: 사용자 설명서 (4 페이지)
페이지 인쇄
Printing on Shrink Tube
How to use Heat Shrink Tube
J
This printer prints on two sizes of heat shrink tube, 203 (1/8") and 205
(3/16").
If printing on heat shrink tube is light, turn up the print density.
Before use
1. Set the dedicated tape.
2. Enter text, and then print on the tube.
3. Put a wire through the tube.
4. Direct hot air from an industrial-use heat gun onto the entire surface of
the tube, shrinking it to the wire. Refer to the manual of your heat gun to
use it properly with heat shrink tube.
Printing a Barcode
Creating a label including a barcode
J
• Enter barcodes according to their standards.
• Check the printed labels with your barcode reader to ensure they can be
correctly read.
• Supported barcode: CODE39, CODE128, ITF, CODABAR, UPC-A, UPC-E, EAN-8,
EAN-13
1. Press
+
.
2. Select an item with
, and press
3. After setting the barcode, enter the code.
Creating a Label with a special form
To create labels with a special form, a message
confirming that the text will be deleted may
appear when
is pressed. Press
the current text and to show the special form.
MEMO
To exit the following special form mode, press
, then select the "9.Exit" and press
Specifying the Label Length
If the font size is set to "Auto", the font size will adjust automatically
allowing you to create labels of a specified length.
1. Press
.
2. Select "Label length" with
3. Select a value with
or enter it, and press
Maximum length: 40cm (15.0 inch)
"Auto": Adjusts to the proper length automatically.
4. Select a text alignment setting with
5. Press
.
6. Select "Auto" with
, and press
7. Enter text.
.
to delete
.
, and press
.
.
, and press
.
.
Create Folder Tab Label
Creating a folder tab label
J
1. Press
.
2. Select from "1.Tab:Medium", "2.Tab:Small" or "3.Tab:Large" with
and press
.
3. Select a value with
or enter label length, and press
Maximum length: 12.5cm (5.0 inch)
4. Enter text.
Create a Ribbon Label
Creating a ribbon
J
1. Press
.
2. Select "8.Ribbon" with
3. Select a value with
or enter it, and press
Length range: 20-40 cm (8.0-15.0 inch)
4. Enter text.
Cable Labels
Creating a label for cables
J
Flag labels wrapping a cable
1. Press
.
2. Select from "4.Flag:Hori.", "5.Flag:Vert." or "6.Flag:Edge" with
press
.
3. Select a value with
or enter label length, and press
Maximum length: 12.5cm (5.0 inch)
4. Enter text.
Labels wrapping a cable
1. Press
.
2. Select "7.Wrap" with
, and press
3. Select a value with
or enter label length, and press
Maximum length: 12.5cm (5.0 inch)
4. Enter text.
.
, and press
.
.
.
.
.
,
, and
9