Motorola HT750-LS 기본 서비스 매뉴얼 보충 자료 - 페이지 31

{카테고리_이름} Motorola HT750-LS에 대한 기본 서비스 매뉴얼 보충 자료을 온라인으로 검색하거나 PDF를 다운로드하세요. Motorola HT750-LS 44 페이지. Professional portable radio

Chapter 5

Radio Tuning, Programming, and Cloning

5.1

Cloning is the same for both the Conventional and LTR radio. Cloning is the process of copying the

content of one radio (source radio) into another radio (target radio). Radio content refers to system-

type features such as frequency, squelch type options, trunking, etc.

Note: Cloning can be performed only on radios with identical model numbers and software options.

Radio functionality inherent in one radio cannot be cloned to another radio that does not contain the

same functionality. Tuning and alignment information are not transferable and are not affected by

cloning.

Signaling Identiﬁcation Numbers (IDs) are duplicated in the cloning process. Unique IDs may be

assigned with the CPS.

Note: Unsuccessful cloning attempts will not damage the radio.

Procedure:

1. Turn source and target radios off.

2. Connect cloning cable to side connector of both radios.

3. Turn on target radio.

4. On source radio, simultaneously press 'side buttons 1 and 2', shown in Figure 5-3, then turn radio

on. Both radios produce a "clone-entry" tone and turn on their green LEDs. Display radios show

"Cloning To" (source radio) and "Program" (target radio).

5. Release both side buttons. The electronic transfer process begins and will take approximately one

to three minutes.

6. When cloning is completed, both radios reset themselves and turn their green LEDs off. The

source radio produces a "clone-exit" tone and displays "Clone Complete".

7. Turn both radios off.

8. Disconnect the cloning cable from both radios and turn them on for normal operation.

On/Off

Knob

Side Button 1

(programmable)

Side Button 2

(programmable)

Side Button 3

(programmable)

Figure 5-1. Radio Side Button Locations

5-1