Motorola MTP850 설치 매뉴얼 - 페이지 4

{카테고리_이름} Motorola MTP850에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Motorola MTP850 8 페이지. Digital car kit
Motorola MTP850에 대해서도 마찬가지입니다: 기본 사용 설명서 (42 페이지), 빠른 시작 매뉴얼 (2 페이지)

페이지 인쇄

Table 1: FTN6790B Specifications

Input Voltage

Range

Output Voltage

Max. Output

Current

Dimensions

(regulator unit

block)

Input cable

Output cable

Installation

1. The positive supply to the regulator should be taken from an

ignition switched source. This can be connected to the same

supply as used for ignition sense to DCK control box (green wire).

The positive supply must be fused at maximum 1 A rating.

2. Connect coaxial cable end to 5 V input terminal on diplexor unit.

3. Run supply cable to selected connection point, ensuring that it is

secured from being damaged and does not interfere with any

vehicle controls or airbag deployment.

4. Connect grey regulator positive feed wire to ignition sense feed,

via 1 A fuse (using holder and connectors supplied).

Specification

7–30 V

5 V

40 mA

41 x 12.5 x 12.7 mm

Twin Figure-8

Length: 560 mm

Negative marked black

tracer line

RG174 Coaxial Cable

Length: 550 mm

Terminated FME Jack (f)

Centre contact positive

supply

Kit Content

Regulator unit

moulded with

input and output

cables

1 x Fuseholder

1 x Fuse 1A rated

2 x Blade

connectors - red

insulated