Motorola HS700 빠른 시작 - 페이지 2

{카테고리_이름} Motorola HS700에 대한 빠른 시작을 온라인으로 검색하거나 PDF를 다운로드하세요. Motorola HS700 2 페이지. Bluetooth handsfree headset

페이지 인쇄

To turn your headset on, open the

headset boom. The indicator light flashes

blue if paired with another device, or is

H700

steadily lit in purple if ready to be paired.

Bluetooth®

To turn your headset off, close the

Handsfree Headset

headset boom. The indicator light will turn

off.

To conserve battery power, turn off your

headset when you don't plan to use it for

IMPORTANT:

Be sure to first follow the

Quick Start Guide

on the reverse side to

complete initial setup of

Multi-Color

your H700.

Indicator Light

Function

Make a voice dial call

End a call

Receive a call

Reject a call

Redial last call

Note: Your H700 supports both Handsfree and Headset

Profiles. Accessing call functions depends upon which

profile your phone supports. See your phone's user's guide

for more information.

TURNING ON AND OFF

MAKING CALLS

Action

Function

Tap the Call button

Answer a second

incoming call

and speak the

name after the tone

Tap the Call button

Toggle between two

active calls

Open headset boom

Join a 3-way call

or tap the Call button

(if boom is already

Put an active call on

open)

hold or resume a call

Press and hold the

on hold

Call button until you

Transfer a call from the

hear a beep

phone to the headset

Press and hold the

Disable the

Call button until you

indicator light

hear a beep

Mute or unmute a call

Note: Some features are phone/network dependent.

WEARING THE

HEADSET

You can wear your H700 headset on your left or

Open the headset boom, then open the

right ear. The headset comes ready for the right

earhook (45 from the headset).

ear. To change the headset for the left ear:

Loop the earhook over your ear.

Press the headset to your ear.

Point the headset boom towards your

mouth.

MAKING CALLS

CONTINUED

Action

Press and hold the

Call button (places

first call on hold)

Press and hold

the Call button

Press and hold

both Volume buttons

Press and hold the

Call button until you

hear a beep

Open headset boom

Press and hold

both Volume

buttons for 3 to 4

seconds

Tap both Volume

buttons

CHANGING FOR USE

ON OTHER EAR

Open the headset boom,

then open the earhook

(90 from the headset).

Gently lift and pull the

top of the earhook up

1 Open Earhook

and off the upper hinge

pin. Then, pull it away to

remove it.

2 Pull Earhook Up

Flip the headset over.

Hook the bottom of the

earhook onto the lower

hinge pin, then lift and

Hinge Pin

pull the top of the

earhook over the upper

hinge pin.

INDICATOR LIGHTS

With the Charger Plugged In

Indicator Light

Headset Status

Red (steady)

Charging (less than

80% charged)

Yellow (steady)

Charging (more than

80% charged)

Green (steady)

Charging complete

With No Charger Plugged In

Indicator Light

Headset Status

Off

Power off

Purple (steady)

Pairing mode/

Volume button

orientation

Red

Battery low

Blue (10 rapid flashes) Pairing successful

Blue (slow pulse)

Connected (on a call)

Blue (quick flash)

Standby (not on call)

Note: After 5 minutes of inactivity, the light stops flashing to

conserve power, but the headset remains in standby mode.

CHANGING VOLUME

BUTTON ORIENTATION

You can also change the orientation of the

volume buttons on your headset.

Turn the headset power off by closing

the headset boom.

Press the Call

button until the

indicator light becomes steadily lit in

purple, then press the Volume button

you want to assign as the "volume up"

button.

Call

Button

Volume

Buttons

AUDIO TONES

The audio tones provide information about your

headset status.

Audio Ton e

Headset Status

Single high tone when

Volume at minimum

pressing Volume button

or maximum

Five rapid high tones

Low battery

repeated every 60 sec.

No audio indications;

Out of range

deteriorating quality

Ring tone

Incoming call

Single high tone

Pairing confirmation

Single low tone

Voice activation

Dual high/low tone

Voice tag not

recognized

Single high tone

End call

Low to high tone

Phone network

not available

Two ascending tones

Mute enabled

Two descending tones

Mute disabled