Motorola im240 - Wireless PC Card Modem 사용자 설명서 - 페이지 32

{카테고리_이름} Motorola im240 - Wireless PC Card Modem에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Motorola im240 - Wireless PC Card Modem 43 페이지. Motorola wireless modem user's guide

페이지 인쇄

Troubleshooting

Manually Configuring im240 Wireless

Modem

On Some Tablet PCs it has been noted that the im240 fails to install

successfully. The Windows "Found New Hardware Wizard" will report

an error message "This device cannot start. (Code 10)". This is due

to the OS not being able to assign the IRQ to the modem. Due to this

the Dashboard installation program will not be able to finish the modem

installation properly. If you get the above error message follow the

steps below to resolve this issue without exiting from the Dashboard

installation.

1 Click Start >Control Panel and double click System.

Note: If Control Panel is not found in the Start menu,

click Start >Settings >Control Panel

2 Click Hardware Tab and then click Device Manager.

3 Locate the "Motorola im240 PC Card modem" and double click to

view the properties.

4 Click on the Resources Tab.

5 Click on the "Set Configuration Manually" button.

6 Uncheck "Use automatic settings" check box.

7 Change Setting based on to "Basic configuration 0001".

8 In Resource settings, select IRQ.

9 Click on the "Change Setting" button to open the "Edit Interrupt

Request" dialog box.

10 Select an IRQ which will not conflict with any other device. This can

be verified in the Conflict information status box. If it says No

devices are conflicting then that IRQ can be selected.

11 Click OK to close the "Edit Interrupt Request" dialog box.

12 Click OK to close the "Motorola im240 PC Card Modem

Properties" dialog box.

13 Click Yes to confirm the manual resource settings.

14 The Modem should now be installed properly.

After following the steps above continue with the Dashboard

installation.