Motorola SURFboard SBG900 설정 매뉴얼

{카테고리_이름} Motorola SURFboard SBG900에 대한 설정 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Motorola SURFboard SBG900 7 페이지. Wireless cable modem gateway with integrated surfboard technology
Motorola SURFboard SBG900에 대해서도 마찬가지입니다: 빠른 설치 매뉴얼 (16 페이지), 기술 사양 (2 페이지), 일반 정보 매뉴얼 (17 페이지), 사양 (4 페이지)

페이지 인쇄

TCC Motorola SBG900 Setup Guide

Connect the Power cord to the modem and a

wall outlet or surge protector

Connect the Cable line from the Cable jack

(or splitter) to the back of the modem.

Wait until the first four lights of modem are solid,

Connect computer to modem.

Your computer has an Ethernet card:

Connect an Ethernet cord from the back of your

computer to the Ethernet plug on the modem.

Your computer does not have an Ethernet card:

Connect a USB cord from the USB port on the

modem to an available USB port on the front or

back of your computer. Have the USB Driver disk/CD

ready before continuing. You will be immediately

asked to provide USB drivers when you connect the

USB cord to the PC and modem.

Note: USB may not work with Windows 95 or 98.

Your computer has neither Ethernet nor USB:

You will need to buy and install an Ethernet card for

your computer before continuing.

Open Internet Explorer (or other browser)

If service is ready and devices are connected properly,

you should see a "Cable Modem Login" screen. Type

your TCC Username (login) and Password. Your

password is case-sensitive. If you do not have your

password, contact our office and it can be picked up or

sent to you.

Initial connection requires a computer directly plugged into the modem via Ethernet or USB. Once a

wired connection is established, you can log into the router administration console to configure Wireless

Access and setup Security.

Connecting your Motorola SBG900 Cable Modem

Ethernet...

USB port