Epson U230 - TM Two-color Dot-matrix Printer 사용자 설명서 - 페이지 10
{카테고리_이름} Epson U230 - TM Two-color Dot-matrix Printer에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Epson U230 - TM Two-color Dot-matrix Printer 14 페이지. Solutions for pos and financial applications
Epson U230 - TM Two-color Dot-matrix Printer에 대해서도 마찬가지입니다: 사양 (2 페이지), 사양 (8 페이지), 매뉴얼 (10 페이지)
페이지 인쇄
English
Installing the Paper Roll
CAUTION:
Be sure not to touch the manual cutter. Otherwise your fingers might be
injured.
Note:
Be sure to use roll paper that meets the specifications.
1.
Using scissors, cut the leading edge of the roll paper, as shown in
illustration E.
2.
Open the paper roll cover; then turn on the printer.
3.
Insert a paper roll; then hold both edges of the paper and insert it straight
into the paper insert slot until the paper is fed automatically, as shown in
illustration F.
Note:
Note the direction the paper comes off the roll, as shown in Illustration G.
4.
When the paper feeding is finished, tear off the fed paper with the manual
cutter.
5.
Close the paper roll cover.
6.
When the
printer online.
Note on the PAPER OUT LED
When the paper has reached the end or near end, the
comes on. The buzzer will also sound if the printer has been set for the buzzer
to sound for the end or near end of the paper. Opening the cover to replace
paper or pressing the
Installing the Ribbon
CAUTION:
Be sure not to touch the manual cutter. Otherwise your fingers might be
injured.
Use the EPSON ERC-38. The use of any ribbon cassettes other than those
approved by EPSON may damage the printer and will void the warranty.
1.
Turn on the printer. Turn the knob on the ribbon cassette, as shown in
illustration H.
2.
Open the paper roll cover and cutter cover.
3.
Lift the autocutter, using the tab, as shown in illustration I; then insert the
new ribbon, as shown in illustration J.
4.
Turn the knob 2 or 3 times again and check if the ribbon cassette is in the
right position.
10 TM-U230 User's Manual
PAPER OUT
LED flashes, press the
FEED
button stops the buzzer sound.
FEED
button to set the
PAPER OUT
LED