Epson 2090 - LQ B/W Dot-matrix Printer 사용자 설명서 - 페이지 45

{카테고리_이름} Epson 2090 - LQ B/W Dot-matrix Printer에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Epson 2090 - LQ B/W Dot-matrix Printer 48 페이지. Epson lq-2090: product brochure
Epson 2090 - LQ B/W Dot-matrix Printer에 대해서도 마찬가지입니다: 매뉴얼 (11 페이지), 기술 요약 (7 페이지), 사양 (2 페이지)

Epson 2090 - LQ B/W Dot-matrix Printer 사용자 설명서
Chapter 5
Product Information

Safety Instructions

Hot Parts Caution Symbol

This symbol is placed on the print head and other parts to indicate that
K
they may be hot. Never touch those parts just after the printer has been
used. Let them cool for a few minutes before touching them.

Important Safety Instructions

Read all of these safety instructions before using the printer. In addition, follow
all warnings and instructions marked on the printer itself.
Do not place the printer on an unstable surface or near a radiator or heat
source.
Place the printer on a flat surface. It will not operate properly if it is tilted or
placed at an angle.
Do not block or cover the slots and openings in the printer's cabinet, and do
not insert objects through the slots.
Use only the type of power source indicated on the printer's label.
Connect all equipment to properly grounded electrical outlets. Avoid using
outlets on the same circuit as photocopiers or air control systems that
regularly switch on and off.
Do not use a damaged or frayed power cord.
If you use an extension cord with the printer, make sure the total ampere
rating of all devices plugged into the extension cord does not exceed the
cord's ampere rating. Also, make sure the total ampere of all devices
plugged into the electrical outlet does not exceed the electrical outlet's
ampere rating.
Unplug the printer before cleaning it, and always clean it with a damp cloth
only.
Do not spill liquid onto the printer.
Except as specifically explained in the user documentation, do not attempt
to service the printer yourself.
Unplug the printer and refer servicing to qualified service personnel under
the following conditions: if the power cord or plug is damaged, if liquid has
entered the printer, if the printer has been dropped or damaged, if it does
not operate normally or exhibits a distinct change in performance.
Adjust only those controls that are covered by the operating instructions.
Product Information
45