Epson 2190N - FX B/W Dot-matrix Printer 사용자 설명서 - 페이지 39
{카테고리_이름} Epson 2190N - FX B/W Dot-matrix Printer에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Epson 2190N - FX B/W Dot-matrix Printer 48 페이지. Impact printers
Epson 2190N - FX B/W Dot-matrix Printer에 대해서도 마찬가지입니다: 매뉴얼 (11 페이지), 사양 (2 페이지), 기술 요약 (7 페이지)
페이지 인쇄
Setting
Auto CR (available in IBM
PPDS emulation mode)
IBM character table
Default-setting mode
Follow the steps below to enter the default-setting mode. If you use
single sheets, you need to load a new sheet of paper each time the printer
ejects a printed page.
1.
Make sure the printer is on and paper is loaded. Then press the
buttons (Item
Menu
Tear Off/Bin lights turn on.
The printer enters default-setting mode and prints a line showing
which language is currently selected for printing the instructions.
The selected language is underlined.
2.
If you want a different language, press the Item
printout shows the language you want underlined.
3.
Press the Set button to accept the language. The printer prints a line
asking if you want to print all the current settings.
4.
To print a list of all the current settings, press the Set button. The
printer prints all the settings and then the first setting again. Go to
step 5.
To go through the settings one at a time, press the Item D or Item U
button. The printer prints the first setting and its current value.
5.
Press the Set button to scroll through the options for the selected
setting until you see the one you want.
Press the Item D or Item U button to select the next or previous
setting you want to change.
6.
Repeat step 5 for any other settings you want to change.
7.
When you finish, press the Menu buttons again to exit
default-setting mode.
Your new settings become the printer's defaults.
Options (default in bold)
Off, On
Table 2, Table1
and Set ) until the printer beeps and both the
U
button until the
D
Using the Control Panel
39