Epson 410W - PowerLite WXGA LCD Projector 운영 매뉴얼 - 페이지 41

{카테고리_이름} Epson 410W - PowerLite WXGA LCD Projector에 대한 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Epson 410W - PowerLite WXGA LCD Projector 47 페이지. Remote control information
Epson 410W - PowerLite WXGA LCD Projector에 대해서도 마찬가지입니다: 사용자 설명서 (42 페이지), 빠른 설정 매뉴얼 (6 페이지), 사용자 설명서 (1 페이지), 사양 (2 페이지), 적합성 선언 (4 페이지), 사용자 설명서 (2 페이지), 부품 목록 (1 페이지), 제품 지원 게시판 (25 페이지), 제품 지원 게시판 (22 페이지), 제품 지원 게시판 (28 페이지), 제품 지원 게시판 (41 페이지), 제품 지원 게시판 (15 페이지), 제품 지원 게시판 (22 페이지), 설치 핸드북 (5 페이지)

페이지 인쇄
Epson 410W - PowerLite WXGA LCD Projector 운영 매뉴얼
E-mail notification
The details contained in the e-mail message can consist of the following.
Message
Internal Error
Fan error
Sensor error
Lamp Cover Open
*
Lamp failure at power on
*
Lamp Error
*
Supply System Error (Ballast)
High internal temperature error
Low air flow error
Air filter air flow sensor error
Cinema filter error
Shutter error
Cooling system error (Peltier
element)
Cooling system error (pump)
High-temperature warning
*
Replace Lamp
*
Lamp error
*
Lamp failure at power on
*
Supply System Error (Ballast)
Replace Air Filter
No Air Filter
Low Air Flow
Air Flow Sensor Err.
Remedy
See your projector User's Guide
Message
Cinema filter warning
Shutter warning
Clean Air Filter Notice
No signal
Other error
Auto Iris Error
Network error (TCP connection
error)
Network error (ESC/VP.net
communication error)
Network error (Monitor Password
authentication error)
*
When the projector has 2 lamps, the additional information, such as
(Lamp 1) or (Ballast 1), is displayed after the message so that you can know
which lamp has problems/warnings.
41
Remedy
See your projector User's Guide
No image signals are being received
by the projector. Check the
connection status and check that the
power for the connected equipment
is turned on.
Stop using the projector, disconnect
the power cable from the electrical
outlet, and contact Epson.
Check the following items.
Check that the projector's power is
turned on.
Check that the LAN cable is
connected.
Check that Standby Mode is set to
Communication On (or Network On)
or Network Monitoring is set to On in
the projector's configuration menu.
s Projector's User's Guide
Check that the projector has been
correctly connected to the network.
s Projector's User's Guide
Check the projector's Monitor
Password.