Adjusting the Brightness
The brightness of an image depends on the source you are
projecting and the amount of light in the room. If the image is
too bright or not bright enough, do one of the following:
Change the
Brightness
Select
or
for the
Low
High
the Setting menu. Low Brightness mode extends the life of
the lamp and decreases the fan noise.
Adjusting the Color Mode
You may want to adjust the color mode to select a setting
that is appropriate for the image you're projecting and the
environment in which you're projecting it. The following table
lists the available color modes.
Color mode
Description
For matching the color palette of standard sRGB
sRGB
computer displays.
For increased brightness in bright rooms (the
Dynamic
default for non-computer display).
For computer presentations (the default when
Presentation
projecting from a computer with analog video).
For optimizing movie images with increased
Theater
contrast.
For increased brightness when playing video
Living Room
games or watching TV in a bright room.
For projecting accurate colors on a green
Blackboard
chalkboard (adjusts the white point).
To change the color mode, press the
the remote control repeatedly until you see the mode you want.
The currently selected setting appears in the upper right corner
of the screen. You can also use the projector menu system to
select the Color Mode setting in the Image menu.
Sleep Mode
You can set the projector to automatically turn off the lamp and
enter "sleep mode" when it has not received any signals for
30 minutes. This conserves electricity, cools the projector, and
extends the life of the lamp. If you want to start projecting
again, press the
button. If you are done using the
P
Power
projector, unplug the power cord.
You can enable sleep mode in the Extended menu under
. (Sleep mode is off by default.)
Operation
setting in the Image menu.
option in
Brightness Control
button on
Color Mode
Epson PowerLite 755c/765c Projector
Using Direct Power On
The Direct Power On function enables faster setup. The
projector starts up automatically when you plug it in; you won't
have to press the P
Power
Follow these steps to enable Direct Power On:
1. Press the
button on the remote control and select the
Menu
menu.
Extended
2. Choose
Operation
3. Choose
Direct Power On
4. Highlight
and press
ON
5. Press
or
Esc
Menu
Note:
When Direct Power On is enabled, shut down the projector as you
normally would. Follow the instructions in the next section. (The
projector will start automatically when power is restored after a
power failure if it is plugged in.)
Shutting Down the Projector
When you've finished using the projector, follow the
recommended procedure to shut it down. This extends the
lamp life and protects the projector from possible overheating.
1. Turn off any equipment plugged into the projector.
2. To turn off the projector, press the P
projector or remote control. You see a confirmation message.
(If you don't want to turn it off, press any other button.)
3. Press the P
Power
When the projector beeps twice, it's safe to unplug it.
(If the projector is mounted on the ceiling, you'll need to
wait 10 seconds for the projector to cool down before you
can unplug the power cord.)
If you want to turn the projector on again, make sure the
light is not flashing. Then press the P
Power
button.
Caution:
To avoid damaging the projector or lamp, never unplug the
power cord when the
8/05
Epson PowerLite 755c/765c Projector
button.
and press
.
Enter
and press
.
Enter
.
Enter
to exit.
button on the
Power
button again. The lamp is turned off.
Power
light is green or flashing orange.
Power
7
-
페이지 인쇄