Epson 7800 - Stylus Pro Color Inkjet Printer 공지 사항 시트 - 페이지 2

{카테고리_이름} Epson 7800 - Stylus Pro Color Inkjet Printer에 대한 공지 사항 시트을 온라인으로 검색하거나 PDF를 다운로드하세요. Epson 7800 - Stylus Pro Color Inkjet Printer 4 페이지. Stylus pro 800 series
Epson 7800 - Stylus Pro Color Inkjet Printer에 대해서도 마찬가지입니다: 포장 풀기 및 설정 매뉴얼 (27 페이지), 브로셔 및 사양 (8 페이지), 사양 (4 페이지), 시작하기 매뉴얼 (10 페이지), 사용자 설명서 (11 페이지), 빠른 참조 매뉴얼 (12 페이지), 보충 설명서 (1 페이지), 제한 보증 (12 페이지), 브로셔 및 사양 (8 페이지), 제품 지원 게시판 (10 페이지), 브로셔 및 사양 (16 페이지)

페이지 인쇄
Epson 7800 - Stylus Pro Color Inkjet Printer 공지 사항 시트
About Platen Gap
In the Control Panel section of the Reference Guide, the description about Platen Gap on the Custom Paper
menu is incorrect. WIDEST is not supported, so read it as below.
You can adjust the distance between the print head and paper. Normally, leave this set to STANDARD.
If you find that printed images are smeared, select WIDE. Select NARROW for printing on thin paper, or
WIDER for printing on thick paper.
Note:
There is also Platen Gap on the Printer Setup menu, but this one supports WIDEST. Only Platen Gap on the
Custom Paper menu does not support WIDEST.
The setting will return to STANDARD after you turn the printer on and off.
Cleaning the Printer
In the Maintenance and Transportation section of the Reference Guide, we have added some more
information for Cleaning the Printer, so read it as below.
To keep your printer operation in its top condition, clean it thoroughly if it becomes soiled.
w
Warning:
Be careful not to touch the gears inside the printer.
c
Caution:
Never use alcohol or thinners to clean the printer; these chemicals can damage the components as well
as the case.
Be careful not to get water on the printer mechanism or electronic components.
Do not use a hard or abrasive brush.
Do not spray the inside of the printer with lubricants; unsuitable oils can damage the mechanism.
Contact your dealer or a qualified service person if lubrication is needed.
1. Make sure the printer is turned off and all the lights are off, and then unplug the power cord. Leave
the printer for a minute.
c
Caution:
Do not touch the following parts; otherwise, printouts may be soiled.
2
Roller
Ink absorption
Print head guide