Epson C11C558001 - LQ 590 B/W Dot-matrix Printer 사용자 설명서 - 페이지 33
{카테고리_이름} Epson C11C558001 - LQ 590 B/W Dot-matrix Printer에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Epson C11C558001 - LQ 590 B/W Dot-matrix Printer 48 페이지. Epson lq-2090: product brochure
Epson C11C558001 - LQ 590 B/W Dot-matrix Printer에 대해서도 마찬가지입니다: 매뉴얼 (11 페이지), 기술 요약 (7 페이지), 사양 (2 페이지)
페이지 인쇄
Adjusting the top-of-form position
The top-of-form position is the position on the page where the printer
starts printing. If your printing appears too high or low on the page, you
can use the Micro Adjust function to adjust the top-of-form position, as
described below. Your top-of-form position setting remains in effect until
you change it, even if you turn off the printer.
Caution:
c
Never use the knob to adjust the top-of-form position; this may damage the
printer or cause it to lose the top-of-form position.
1.
Make sure the printer is turned on.
2.
Load paper. (If the tractor is in a push position, press the Load/Eject
button to advance continuous paper to the current top-of-form
position.) If necessary, lift the printer cover so you can see the paper
position.
3.
Hold down the Pause button for three seconds. The Pause light
flashes and the printer enters Micro Adjust mode.
4.
Press the LF/FF D button to move the top-of-form position up on the
page, or press the Load/Eject U button to move the top-of-form
position down on the page.
5.
Press the Pause button to exit Micro Adjust mode.
Paper Handling
33