Epson ChromaBlast 1.0 시작하기 매뉴얼 - 페이지 17
{카테고리_이름} Epson ChromaBlast 1.0에 대한 시작하기 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Epson ChromaBlast 1.0 47 페이지. For epson stylus pro 4880
Epson ChromaBlast 1.0에 대해서도 마찬가지입니다: 소유자 매뉴얼 (13 페이지)
페이지 인쇄
Sawgrass Technologies, Inc.
Printing and Heat Transfer Instructions
RECOMMENDED APPLICATIONS
White or light colored fabrics in 100% cotton.
PRINTING
Print using the supplied ChromaBlast 4880 Driver v1.0 program only.
The print side of ChromaBlast media is opposite the ChromaBlast logo.
For the Epson 4880 place print side face up in the printer tray.
Mirror Image: Check this box in the ChromaBlast Driver to ensure the image
prints in reverse and that text appears correctly when image is transferred. If
your image is already reversed in your graphic program, leave this box
unchecked.
TRANSFERRING THE IMAGE USING A COMMERCIAL HEAT PRESS
1. If desired, you may trim the non-printed area before transferring,
leaving .25 in. margin around the printed area.
2. Place garment on the heat press. Cover with ChromaBlast paper
with image face down.
3. Press image according to proper pressure, heat, and time settings.
4. Peel the paper off the shirt while the shirt is still hot using an even
motion.
5. Stretch the image area while the shirt is hot from both left to right
and top to bottom to reduce the hand.
HEAT PRESS SETTINGS
Pressure: Heavy. If using a pneumatic press, set the pressure to 60 psi.
Temperature:
375°F - 400°F
Time:
40 seconds.
than 375°F, reduce the transfer time to prevent scorching.
In order for the ChromaBlast Ink and Media to bond to the cotton fibers it
is critical that the heat press settings above be used to achieve the best
possible results.
STORAGE INSTRUCTIONS
Store ChromaBlast media in a cool, dry area within the provided plastic
storage bag. Do not remove from carton until ready to use.
(190°C - 205°C)
If you press the garment at a temperature higher
ChromaBlast
Getting Started Guide for the EPSON Stylus Pro 4880
™
15