Selecting the Correct Media Type
Select the Type (Windows) or Media Type (Macintosh)
setting according to these guidelines:
For this paper
Plain paper sheets or envelopes
EPSON Premium Bright White Paper
EPSON Photo Quality Ink Jet Paper
EPSON Photo Quality Ink Jet Cards
EPSON Matte Paper Heavyweight
EPSON Double-Sided Matte Paper
EPSON Archival Matte Paper
EPSON Photo Paper
EPSON Glossy Photo Paper
EPSON All Purpose Glossy Paper
EPSON Photo Quality Glossy Paper
EPSON Glossy Photo Greeting Cards
EPSON Premium Semigloss Photo Paper Premium Semigloss Photo
EPSON Iron-On Transfer Paper
EPSON Ink Jet Transparencies
Placing Your Original Document
1. Open the scanner lid.
2. Place your document face-down on the glass, in the corner
shown below. Move your document about 0.1 inch from
the top and side edge so your entire document is scanned.
3. Close the scanner lid.
Note:
If you place your document against the guides, the edges next to the
guides won't be scanned.
If you need to scan a thick document, such as a book, you can
remove the scanner lid to scan. Gently press down the original to
keep it flat on the document table. Be sure to replace the scanner id
when you're finished.
Select this Type or Media
Type setting
Plain paper
Bright White Paper
Photo Quality Ink Jet Paper
Matte Paper - Heavyweight
Double-Sided Matte Paper
Enhanced Matte Paper
Glossy Photo Paper
Paper
Photo Quality Glossy Film
Ink Jet Transparencies
10/02
Stand-Alone Copying
Basic Copying
1. Place your document face-down on the glass, as shown in
the previous section.
2. The default copy settings are displayed on the control panel.
Change any necessary copy settings, as described in
"Changing Copy Settings" below.
3. Press the Color Copy button (for color copies) or B&W
Copy button (for black and white copies). Your document
is scanned then printed. If you're using the 2-up or 4-up
Copy Mode setting (see "Type of Copies" on page 6), repeat
these steps for your second page.
Note: Your copied image size may not be the exact same size as your
original.
Changing Copy Settings
The current copy settings are shown on the LCD screen. You
can change copy settings using the control panel, as described
below.
Current settings are shown here
Reset
button
When you finished changing a setting, press the
Note:
To clear a setting, press the Reset button. To clear all the setting
changes you've made, press and hold the Reset button for at least 3
seconds.
If you'll be changing the Copy mode setting (as described in "Type of
Copies" on page 6), select your Copy mode before selecting any
other copy settings.
EPSON Stylus CX5200
Menu
Copies/Value
buttons
buttons (+ and –)
Stop
EPSON Stylus CX5200
Stop
button
button.
- 5
페이지 인쇄