Epson EasyMP Monitor 4.53 운영 매뉴얼 - 페이지 31
{카테고리_이름} Epson EasyMP Monitor 4.53에 대한 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Epson EasyMP Monitor 4.53 48 페이지. Operation guide - easymp monitor v4.53
페이지 인쇄Monitoring window layout
Shows a warning/problem status using the following icons.
*6
Replace Lamp
Replace Lamp (Lamp 2)
Lamp error (Lamp 2)
Lamp failure at power on
(Lamp 2)
Replace Air Filter
Low Air Flow
Supply System Error (Ballast
1)
Cinema filter warning
Lamp Cover Open
Lamp Error (Lamp 1)
Lamp failure at power on
Lamp failure at power on
(Lamp 2)
Low air flow error
Internal Error
Sensor error
Supply System Error (Ballast
1)
Auto Iris Error
Shutter error
Cooling system error
(pump)
Exhaust vent shutter error
Replace Lamp (Lamp 1)
Lamp error (Lamp 1)
Lamp failure at power on
(Lamp 1)
High-temperature warning
No Air Filter
Air Flow Sensor Err.
Supply System Error (Ballast
2)
Shutter warning
Lamp Error
Lamp Error (Lamp 2)
Lamp failure at power on
(Lamp 1)
High internal temperature
error
Air filter air flow sensor error
Fan error
Supply System Error
(Ballast)
Supply System Error (Ballast
2)
Cinema filter error
Cooling system error
(Peltier element)
Other error
Obstacle Detection warning
Easy Interactive Function
Error
*1 When Temperature level display group view is set to On at Environment
setup in the Tool menu, an icon indicating the internal temperature of the
projector will be displayed on top of the projector icon. The default setting
is Off.
*2 Check the following items.
- Check that the projector's power is turned on.
- Check that the LAN cable is connected.
- Check that Standby Mode is set to Communication On (or Network On)
or Network Monitoring is set to On in the projector's configuration menu.
*3 Check that the projector has been correctly connected to the network.
*4 It describes DVI-D if the projector is equipped with both DVI-D and HDMI
input terminal.
*5 It describes HDMI if the projector is equipped with both DVI-D and HDMI
input terminal.
*6 You can display Replace Lamp at any time by setting a preset in the
Environment setup in the Tool menu.
q
Detectable error information differs with the projector you are using.
Checking properties in detail
You can check the properties of Group and projectors in detail.
31
Obstacle Detection Error