Two Connection Modes
There are two methods of connecting a computer and the projector via a
network by using EasyMP Network Projection.
Advanced Connection Mode
Advanced Connection Mode is an infrastructure connection, and connects
to an existing network system via a network cable.
When connecting to a network via Wired LAN, connect the projector to
the network hub with a commercially available LAN cable.
If you install the optional Wireless LAN unit in the projector, you can
connect to the network via a wireless LAN access point.
Quick Connection Mode (Only when the optional
Wireless LAN unit is installed)
Quick Connection Mode is only available when you install the optional
Wireless LAN unit in the projector.
Quick Connection Mode temporarily assigns the projector's SSID to a
computer creating an ad hoc
network settings after disconnecting.
g
connection, and restores the computer's
p.11
s
• You can easily connect to a computer and project images from the
computer without making network settings.
• This lets you connect easily without a connector cable, and you can
even connect if the projector and the computer are at remote locations.
Steps for Connecting
Use the following steps to connect the computer to the projector and
project in EasyMP Network Projection.
You need to perform steps 1 to 4 only the first time you connect.
1.
Install EasyMP Network Projection on the computer to be connected.
p.6
s
2.
*
Make network settings on the computer and put it into network
connection status. s
p.11
3.
For Quick Connection Mode: Install the optional Wireless LAN unit in
the projector (if already installed, go to step 5).
For Advanced Connection Mode: Enable the Wired LAN or Wireless
LAN adapter in "Port Configurations". s Computer's documentation
9
페이지 인쇄