Epson EMP-8100 커뮤니케이션 매뉴얼 - 페이지 5

{카테고리_이름} Epson EMP-8100에 대한 커뮤니케이션 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Epson EMP-8100 20 페이지. Esc/vp level 6 serial communication manual
Epson EMP-8100에 대해서도 마찬가지입니다: 운영 매뉴얼 (14 페이지), 사양 (1 페이지)

페이지 인쇄

5. COMMAND STRUCTURE

• ECommands are expressed as hexadecimal codes.

• All commands start with an ID code and end with a checksum.

When an ESC/VP command which is sent from the computer is received by the projector, a reply is returned.

However, the replies which are returned by the projector only indicate whether the initial command was received by the projector,

and do not indicate whether the command was executed or not.

Acquisition commands are sent in order to check the execution of a command.

In addition, if the next command is sent before the reply to a previous command has been received from the projector, it may

result in a communication error.

The command structure is shown below.

bytes.

(1) STX

(2) Size

(1) STX

: 0x1D (1 byte)

(2) Size

: Size of a command packet (Specifies a number of the data from 1D to CS) (2 bytes)

Example) To turn the power on over a serial connection

1D 000x 01 01 00 03 01 CS

Example) To check the power status over a serial connection

1D 000x 02 01 00 03

(3) Attribute

: Indicates attributes such as apply command/reply command, OK/Not OK, etc. (1 byte)

The attribute codes are shown below.

Table 5-1. Attribute of the Apply command

Attribute

Attribute code

Set

0x01

Get

0x02

Initialize

0x03

Package

0x05

Table 5-2. Attribute of the Reply command

Attribute

Return Packet for setting (OK)

Return Packet for setting (NG)

Return Packet for getting (OK)

Return Packet for getting (NG)

Return Packet for initializing (OK)

Return Packet for initializing (NG)

Response to package (OK)

Response to package (not OK)

Alert response to commands

ESC/VP Level 6 Serial Communication Manual (Abridged Edition)

(3) Attribute

(4) FromTo

---> 0x0009

---> 0x0008

Sets, reports and indicates values.

Gets the current value.

Initializes a value.

Command which combines the attributes of setting, reporting, indicating and requesting.

Attribute code

0x81

Indicates that the set command received was analyzed correctly.

0xC1

Indicates that the set command received was not analyzed correctly.

0x82

Indicates that the get command received was analyzed correctly.

0xC2

Indicates that the get command received was not analyzed correctly.

0x83

Indicates that the initialize command received was analyzed correctly.

0xC3

Indicates that the initialize command received was not analyzed correctly.

0x85

Indicates that the combined attribute command received has been parsed correctly.

Indicates that the combined attribute command received has not been parsed cor-

0xC5

rectly.

Indicates that the command received contained an error and could not be parsed cor-

0x8F

rectly.

* Command layout is BigEndian.

(5) Group

(6) Item

Caption

5 of 20

* The maximum length for a command is 1024

(7) Parameter

(8) Check Sum