Epson Endeavor WG 제품 지원 게시판
{카테고리_이름} Epson Endeavor WG에 대한 제품 지원 게시판을 온라인으로 검색하거나 PDF를 다운로드하세요. Epson Endeavor WG 15 페이지. Using with ms windows 3.x stylus 400/800+/color printer driver
Epson Endeavor WG에 대해서도 마찬가지입니다: 제품 지원 게시판 (17 페이지), 제품 지원 게시판 (3 페이지), 매뉴얼 (9 페이지)
페이지 인쇄
EPSON AMERICA, INC.
Product Support Bulletin
SUBJECT:
Date: 11/5/94
Page(s): 1 of 2
This bulletin provides additional information to allow printer driver ver 1.03E for the Stylus 400,
800+ and Color printers to complete the installation process when connected to Epson
Progression/Progression4/NX-Epson and Endeavor-WG computers in the MS Windows 3 .x
environment.
When attempting to install the 1.03E printer driver the following warning message appears:
"This driver cannot he updated because it is currently being used by windows.
Wait until Windows is finished using the driver, and then try again."
This is caused by a conflict with the Wingine 256 color video driver and the printer installation
process. The following steps will help complete the installation:
Exit Windows to the DOS prompt, C:\>.
1.
2.
Change directories to Windows (Type CD\Windows ) Hit ENTER
3.
At the C:\Windows prompt type SETUP and Hit ENTER.
After the SETUP screen appears, with the UP and DOWN arrows select the
4.
DISPLAY line. Hit ENTER.
5.
A BOX will appear near the bottom of the screen containing video drivers. With
the DOWN ARROW key, move through the drivers and find either a
WINGINE 32k or 64k color driver or select the Windows VGA driver.
Hit ENTER. Hit ENTER two more times to exit SETUP.
6.
Type WIN to load Windows. In the MAIN program group find
CONTROL PANEL and double click. In CONTROL PANEL find PRINTERS
and double click. Continue with the printer installation from here.
7.
After completing the installation, follow steps 1 through 4 to change back to
the Wingine 256 color driver you wish to use.
MS Windows 3.x Stylus 400/800+/Color Printer Driver problems
using the Progression/Progression4/NX-Epson/Endeavor-WG
EPSON
PSB No: PSB S-0181
Originator: DS