Epson ES-300C 제품 지원 게시판 - 페이지 4

{카테고리_이름} Epson ES-300C에 대한 제품 지원 게시판을 온라인으로 검색하거나 PDF를 다운로드하세요. Epson ES-300C 19 페이지. Laser & non-impact printer error codes
Epson ES-300C에 대해서도 마찬가지입니다: 매뉴얼 (8 페이지), 보충 설명서 (15 페이지), 매뉴얼 (11 페이지), 제품 지원 게시판 (20 페이지), 제품 지원 게시판 (14 페이지), 제품 지원 게시판 (25 페이지), 제품 지원 게시판 (13 페이지)

15. Click on SAVE.

16. Close the SETTINGS notebook.

The next time a Win-OS/2 session is started, you will see the EPSON device driver

load. If you do not, repeat the above steps. If you have migrated a Windows

application to the OS/2 desktop, apply the above steps to that icon instead of the

Win-OS/2 icon. To verify that the configuration is correct, configure the DOS FULL

SCREEN icon using the same methods outlined in steps 6 through 16. Once you

have completed those steps, start a DOS FULL SCREEN session and run the

SCANTEST utility from the \WlNDOWS\TWAIN directory. If SCANTEST runs

successfully, chances are that the Windows session will run properly.

Epson TWAIN v2.xx

There is no special procedure required to setup this version of the driver to run in a

Windows session under OS/2 Warp. Simply launch Windows and install the driver.

Follow the procedures outlined in the user's manual. If the driver does not install

properly, verify that the device drivers mentioned earlier in this section are being

executed.

PSB No: P-0103A

Page: 4 of 4