Epson FX 890 사용자 설명서 - 페이지 40

{카테고리_이름} Epson FX 890에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Epson FX 890 48 페이지. Impact printer
Epson FX 890에 대해서도 마찬가지입니다: 사양 시트 (1 페이지), 사양 (2 페이지), 매뉴얼 (11 페이지), 설정 매뉴얼 (2 페이지), 제품 정보 매뉴얼 (19 페이지), 빠른 참조 (12 페이지), 사양 (2 페이지)

페이지 인쇄

Emulating the Okidata Microline 320/321 Turbo

You can make your FX-890 or FX-2190 work like the Okidata Microline

320 Turbo or 321 Turbo. In Okidata mode, the printer emulates Okidata

functions, and the following additional settings can be selected in the

default setting mode. The default settings (shown in bold) are consistent

with Okidata Microline 320/321 Turbo factory settings.

Feature

Software emulation

Auto tear off wait time

Bottom margin

Line spacing (lines per inch)

Paper out override

Note:

The FX-890 and FX-2190 do not support the USB interface in Okidata mode.

If you want to use your printer in Okidata mode, do not install the

Windows driver that came with your printer. If you have been using an

Okidata driver, you can continue to use it with your printer in Okidata

mode.

If you have been using an Okidata printer, you may want to print out its

default settings for reference before changing modes on the

FX-890/FX-2190. To do this on the Okidata printer, press SHIFT + SEL to

enter Menu mode, and then press PRINT .

To enter Okidata mode on your FX-890/FX-2190, make sure the printer is

turned off. Then hold down the Tear Off/Bin and Pause buttons while

you turn on the printer. The printer beeps once to indicate it is now in

Okidata mode. It remains in Okidata mode until you repeat the above

procedure. To return to FX-890/FX-2190 mode, hold down the Tear

and Pause buttons while you turn on the printer. The printer

Off/Bin

beeps twice and is now operating in FX-890 mode.

When you switch from one mode to the other, any changes you made to

the printer's settings in the original mode are restored to their default

values. You can print the default settings for the printer to check the

current settings and change them if necessary. See page 38.

Using the Control Panel

Printer settings in Okidata mode

IBM PPDS, EPSON ESC/P, Oki ML 320T

0.5 second, 1 second, 2 seconds, Others

4.2 mm, 20 mm, 22 mm, 24 mm, Others

6 LPI, 8 LPI

Off (No), On (Yes)