Epson FX-2190 제품 정보 매뉴얼 - 페이지 11

{카테고리_이름} Epson FX-2190에 대한 제품 정보 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Epson FX-2190 19 페이지. Impact printers
Epson FX-2190에 대해서도 마찬가지입니다: 사용자 설명서 (48 페이지), 사양 (2 페이지), 매뉴얼 (11 페이지), 설정 매뉴얼 (2 페이지), 사양 (2 페이지), 빠른 참조 (12 페이지), 여기에서 시작 (2 페이지)

페이지 인쇄

EPSON FX-890/FX-2190

Setting the Paper Release Lever

Set the paper release lever to indicate the paper source you want

to use, as described in the table below.

Lever position

Description

Single-sheet position

For loading single-sheet paper from the top or front

slot.

Front push tractor position

For loading continuous paper with the tractor

installed in the front push position or when using

the front push and pull tractors in combination.

Rear push tractor position

For loading continuous paper with the tractor

installed in the rear push position or when using

the rear push and pull tractors in combination.

Pull tractor position

For loading continuous paper from the tractor

installed on top of the printer in the pull position.

You can load paper in the front, rear, or bottom

slot.

10 - EPSON FX-890/FX-2190

Adjusting the Paper-Thickness Setting

First turn off the printer and open the printer cover. Then set

the paper-thickness setting for the type of paper you are using.

(See the table below.)

Paper type

Ordinary paper

Thin paper

Carbonless multipart forms with:

2 parts (original + 1 copy)

3 parts (original + 2 copies)

4 parts (original + 3 copies)

5 parts (original + 4 copies)

6 parts (original + 5 copies)

7 parts (original + 6 copies) *

Continuous paper with labels

Postcards

Envelopes

* Available when using the tractor in the bottom or front pull position.

Note: When the temperature is 41°F (5°C) or lower, or 95°F (35°C) or

higher, set the paper-thickness lever one position lower to improve

print quality. Multipart forms with 7 parts cannot be used at these

temperatures.

6/03

Lever position

0 or 1 (single sheets)

0 (continuous paper)

5 or 6