Dimplex 69088905 소유자 매뉴얼 - 페이지 7

{카테고리_이름} Dimplex 69088905에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dimplex 69088905 14 페이지.

페이지 인쇄

Fireplace Installation

WARNING: Ensure the power

cord is not installed so that it is

pinched or against a sharp edge

and ensure that the power cord is

stored or secured to avoid tripping

or snagging to reduce the risk

of fire, electric shock or injury to

persons.

WARNING: Construction

and electrical outlet wiring must

comply with local building codes

and other applicable regulations

to reduce the risk of fire, electric

shock and injury to persons.

WARNING: Do not attempt

to wire your own new outlets or

circuits. To reduce the risk of fire,

electric shock or injury to persons,

always use a licensed electrician.

NOTE: A 15 Amp, 120 Volt

alternating current (VAC) circuit

is required. A dedicated circuit

is preferred but not essential in

all cases. A dedicated circuit will

be required if, after installation,

the circuit breaker trips or fuse

blows on a regular basis when the

heater is operating. Additional

appliances on the same circuit

may exceed the current rating of

the circuit breaker.

Glass Installation

1. Unpack the firebox and the

front glass.

2. Remove the glass retaining

bracket from one side of the

firebox. (Figure 1)

3. Slide the glass into the glass

support track on both the top

and the bottom, until it is fully

inserted.

4. Replace the glass retaining

bracket.

Fireplace Installation

1. Make sure the units 3-Posi-

tion switch is switched OFF

(refer to operating instruction

section).

2. Plug the unit directly into a 15

Amp/120 VAC outlet.

Figure 1