Dimplex 6910470100 서비스 매뉴얼 - 페이지 13

{카테고리_이름} Dimplex 6910470100에 대한 서비스 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dimplex 6910470100 17 페이지.

Flicker Motor Replacement

Tools Required: Phillips Head Screwdriver

Side Cutters

1. Follow the instructions for Preparing the Firebox for Service on page 6.

2. Remove the 2 screws on each side of the bottom panel (4 total). Disconnect the LED connection, and set the bottom

panel aside. (Figure 17)

3. Remove the 2 screws that secure the flicker motor bracket. (Figure 18)

4. Disconnect the flicker motor from the flicker rod.

5. Remove the 2 screws that secure the flicker motor to the flicker motor bracket. (Figure 19)

6. Cut the wire ties from the bundle of wires that include the flicker motor wires.

7. Disconnect the flicker motor connection on the main control board, and connect the connector from the new flicker

motor.

8. Secure the new flicker motor to the flicker motor bracket.

9. Insert the stick of the flicker motor in the rubber grommet from the flicker rod.

10. Secure the flicker motor bracket to the firebox.

11. Secure the previously bundled wires using the previously removed rubber sleeve and the provided wire ties.

12. Secure the bottom panel, ensuring that the LED is reconnected through through the square opening.

13. Reassemble firebox.

Figure 17

Figure 19

Figure 18