Dimplex 6910470300 서비스 매뉴얼 - 페이지 7

{카테고리_이름} Dimplex 6910470300에 대한 서비스 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dimplex 6910470300 17 페이지.

Heater Assembly Replacement

Tools Required: Phillips Head Screwdriver

Side Cutters

Pliers

1. Follow the instructions for Preparing the Firebox for Service on page 6.

2. Remove the center rail (number of screws will vary by model.)

3. Remove the 4 screws that hold the electronics cover panel.

4. Remove the 2 screws on each heater assembly bracket (4 screws total).

5. Trace the 4 wires from the defective heater assembly to the relay board. Disconnect the wiring connections, making

note of their original locations. Cut any restrictive wire ties.

6. Position the new heater assembly and secure it using the brackets and screws previously removed.

7. Connect the wires from the new heater assembly to their correct locations on the relay board.

8. Reassemble the fireplace.

Figure 5

Figure 6

(Figure 5)

(Figure 6)

Electronics

Cover Panel

Center Rail