Ariel Whirlpool BT series 사용자 설명서 - 페이지 6

{카테고리_이름} Ariel Whirlpool BT series에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Ariel Whirlpool BT series 10 페이지.

User manual whirlpool D-series with Bluetooth

Heater:

When water level is above the water level sensor, the heater can be activated. Press the constant temperature button to activate the

heater. Once the water temperature is below the set temperature, the pump and heater will activate. If the set temperature reaches,

the heater will stop automatically. When water level is below the water sensor, the heater and pump stops automatically and the

heater symbol will start flash, if water level will go above water level sensor the heater and pump will start automatically again.

You can set the heater temperature between 35-43 °C. The pre-set temperature is 38 °C. Change setting with the parameter up and

down buttons. To stop the heater, press the constant temperature button, the heater symbol will flash and the pump will run for 10

seconds to cool down the heater and then

cool down heater.

Press the Radio/CD function button to activate the radio. 3 dB will blink for about 5 seconds, then the radio frequency will appear in

the display. The system automatically use the last selected frequency when the radio/CD function is pressed. Once the radio is

activated you can adjust the volume using the parameter setting buttons from 0-19 (3db is default).

To search for a new radio channel, press the set button, then use the parameter setting buttons to select channel. If you press the

parameter setting buttons for 2 seconds, the system will automatically search for a channel. Press the memory button to save the

selected channel. On the display CH(=channel) will appear. Press the parameter setting buttons to choose a preset number from

1-10 and press the memory button to save the channel. To choose a preset channel, press the memory button, then press set

button and use parameter setting buttons to choose preset channel.

To select Bluetooth press the Music function twice (if FM is active, if not Bluetooth is first and only function available).

symbol will appear in the top display and flash and bt will show in the display.

Now the system is searchable and you can start search mode on your Bluetooth device to start pairing. When the "Whirlpool" is

detected, connect and use password 1234 to be able to connect once connected the system will make indication sound.

Once connected the system only connects to music channel, so speech will not go through the system. If there is an incoming or

outgoing call during music streaming, the streaming will stop automatically during the call and start automatically after the call done.

To deactivate the Bluetooth function press the Music button.

stop.

If the system shut down with heater on, the pump will continue run for 5 seconds to

Page 6 / 9