Epson Perfection 3200 Photo 수동 시작 - 페이지 5

{카테고리_이름} Epson Perfection 3200 Photo에 대한 수동 시작을 온라인으로 검색하거나 PDF를 다운로드하세요. Epson Perfection 3200 Photo 8 페이지. Product support bulletin(s)
Epson Perfection 3200 Photo에 대해서도 마찬가지입니다: 브로셔 및 사양 (4 페이지), 제품 지원 게시판 (23 페이지), 매뉴얼 (11 페이지), 먼저 읽어보기 (2 페이지), 업데이트 (1 페이지), 제품 지원 게시판 (17 페이지), 설정 매뉴얼 (2 페이지)

페이지 인쇄

Connect the Scanner

After your software is installed, it's time to get connected.

Remove the sticker from the transportation lock. Use a coin to turn

the lock clockwise one-quarter turn to unlock the scanner carriage.

Remove the sticker from the back of the scanner.

Remove sticker

Connect the cable for the built-in transparency unit to the round

connector on the back of the scanner. You may need to raise the

scanner cover and twist the cable to insert it.

Connect either the USB interface cable that comes with your scanner

or an optional IEEE 1394 (FireWire) cable. Don't connect both.

If you're using USB...

Plug the

USB port. Then plug the

on your computer or USB hub.

Note: Your scanner may not work correctly if you use a USB

cable other than the one supplied by EPSON or if you

connect your scanner to a multi-level USB hub system.

If you're using IEEE 1394 (FireWire)...

Plug one end of the IEEE 1394 cable (not included) into the scanner's

IEEE 1394 port. Then plug the other end into the IEEE 1394 (FireWire,

iLink) port on your computer.

Plug the scanner's power cord into a grounded electrical outlet.

Press the

The scanner lamp comes on.

square end of the USB cable into the scanner's

power button on the front of the scanner to turn it on.

Make sure the

arrow faces up

flat end into any available USB port