Ariel 318 Series 설치 매뉴얼 - 페이지 9

{카테고리_이름} Ariel 318 Series에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Ariel 318 Series 20 페이지.

페이지 인쇄

The charcoal filters are preinstalled if you purchased the range hood with re-circulating kit from us.

I. Remove aluminum filters on hood.

2. Position the charcoal filters onto each side of the motor and tum until it locks. Re-install aluminum

3. Charcoal filters must be replaced after 120 hours of use ( or approximately every 2 to 3 months based on the

average of I to 2 hours of daily cooking time). Available at your local resellers.

Obser

e all governing codes and ordinances.

•

To contact a qualified electrical installer.

•

To assure that the electrical installation is adequate and in conformance with ational Electrical Code,

NFPA 70 - latest edition*, or CSA Standards C22.

0-M9 l - latest edition** and all local codes and ordinances.

If codes permit and a separate ground wire is used, it is recommended that a qualified electrician determine that

the ground path is adequate.

A 120-Yolt, 60

Hz,

AC-only (USA & Canada standard), fused electrical supply is required on a separate 15-amp

circuit, fused on both sides of the

DO NOT ground to a gas pipe.

Check with a qualified electrician if you are not sure that the range hood is properly grounded.

DO NOT have a fuse in the neutral or ground circuit.

Save this Installation Guide for electrical inspector's use.

The range hood must be connected with copper wire/plug only.

The range hood should be connected directly to the fused disconnect (or circuit breaker) box through flexible

armored or non-metallic sheathed copper cable. A U.L. - or C.S.A. - listed strain relief must be provided at each

end of the power supply cable.

Wire sizes (copper wire only) and connections must conform with the rating of the appliance as specified on

the model/serial rating label. Wire sizes must conform to the requirements of the

ANSI/NFPA 70 - latest edition*, or CSA Standards C22.

2 o. 0-M91 - latest edition** and all local codes and ordinances. A U.L. - or C.S.A. - listed conduit con

nector must be provided at each end of the power supply cable (at the range hood and at the junction box).

Copies of the standards listed may be obtained from:

"' National Fire Protection Association

Ballerymarch Park

Quincy, Massachusetl'l 02269

"'"' CSA International

8501 East Pleasant Valley Road

Cleveland, Ohm 44131-5575

Charcoal Filter Installation

NOTE:

Electrical Requirements

IMPORTANT:

(Please consult with a qualified electrician for 110-Volt 60 Hz voltage)

It is the customer's responsibility:

IMPORTANT:

line.

1-94,

Canadian Electrical Code, Part

Canadian Electrical Code Part 1 and C22.

1-94,

filters.

ANSI/

and C22. 2 o.

ational Electrical Code

Page 8