Dimplex ATLANTIC ATC20-AU 사용 설명서 - 페이지 11

{카테고리_이름} Dimplex ATLANTIC ATC20-AU에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Dimplex ATLANTIC ATC20-AU 16 페이지.
Dimplex ATLANTIC ATC20-AU에 대해서도 마찬가지입니다: 소유자 매뉴얼 (5 페이지)

페이지 인쇄
Dimplex ATLANTIC ATC20-AU 사용 설명서
Operation
G
31
Temp Up
Temp
H
18
Down
User Modes:
Mode Name /Description
Change Celsius (
0
 C) to Fahrenheit (
Disable/Enable Heat Options
Press multiple times to increase the heater temperature in 1
highest temperature that can be set 37
Note: Once you stop at your desired temperature this will flash 3 times, then the
display will show the room temperature as detected by the product. If the set
temperature is lower than the detected room temperature the heater will not
activate.
Press multiple times to lower the heater temperature in 1
temperature that can be set is 5
Note: Once you stop at your desired temperature this will flash 3 times, then the
display will show the room temperature as detected by the product. If the set
temperature is lower than the detected room temperature the heater will not
activate.
0
 F)
0
C.
0
C.
Action (Actions cannot be input by remote control)
Press both Temp down (
the unit and hold until beep is heard and display
flashes. (To revert back to Celsius repeat this action)
Hold both Flame cycle (
the product, for 5 seconds, when the heater has
been disabled the product will beep. This will disable
heat control functions on the product only. To enable
heat repeat this action. Note: the remote control will
still be able to operate heat functions.
0
C increments. The
0
C increments. The lowest
) and Temp up ( ) on
) and Heat cycle ( ), on
11