Dimplex BF33DXP 서비스 매뉴얼 - 페이지 16

{카테고리_이름} Dimplex BF33DXP에 대한 서비스 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dimplex BF33DXP 20 페이지. Fireplace
Dimplex BF33DXP에 대해서도 마찬가지입니다: 실용적인 사용자 설명서 (15 페이지), 소유자 매뉴얼 (14 페이지), 사용자 설명서 (14 페이지), 문제 해결 매뉴얼 (2 페이지), 소유자 매뉴얼 (14 페이지), 설치 매뉴얼 (14 페이지)

install cover plate. (See included instructions for elec-

trical installation and requirements.)

14.

Initialize the remote control to the new receiver installed

in the fireplace as per the instructions included in the

remote packaging.

BF PLUg kIT REPLACEMENT

(BFPLUgE)

NOTE: This accessory is only for 110/120V use only.

Tools Required: Philips head screwdriver

WARNINg: If the fireplace was operating prior to

servicing allow at least 10 minutes for light bulbs and

heating elements to cool off to avoid accidental burning

of skin.

WARNINg: Disconnect circuit power before attempt-

ing any maintenance or cleaning to reduce the risk of

electric shock or damage to persons.

Unplug the fireplace from the wall outlet.

Locate the voltage selector switch on the top corner

of the fireplace and make sure the switch is set to 115

V. (The switch should already be set to 115V from the

original installation of this optional accessory cord.

Power cord/Plugs are only approved for operation on

the BF33, BF39 or BF45 in 110 – 120 volt application.

Fireplace must be removable from the wall for access

when a plug kit is being used).

Loosen the screw securing the junction box cover on

the lower right hand side panel toward the back and

remove the cover.

Pull out the four wires marked L1, L2, N, and G.

Replace the black L1 wire from the unit to the non-

ribbed L1 wire from the power cord, connect the red L2

and white N wires from the unit to the ribbed or neutral

from the power cord. (Wide blade on the plug is the

neutral side of the power cord), connect a wire connec-

tor to the green ground wire from the unit.

Ensure that all wire connections are tight.

Re-Install the junction box cover and tighten the screw.

Plug the fireplace back into the outlet for power.

If fireplace has a BFRC-KIT (remote control kit) used

to operate the unit, the remote control may need to be

re-synchronized to the fireplace once power has been

restored to the fireplace.