Dimplex BF33DXP 사용자 설명서 - 페이지 8

{카테고리_이름} Dimplex BF33DXP에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Dimplex BF33DXP 14 페이지. Fireplace
Dimplex BF33DXP에 대해서도 마찬가지입니다: 실용적인 사용자 설명서 (15 페이지), 소유자 매뉴얼 (14 페이지), 서비스 매뉴얼 (20 페이지), 문제 해결 매뉴얼 (2 페이지), 소유자 매뉴얼 (14 페이지), 설치 매뉴얼 (14 페이지)

The Temperature Cutout Switch

The heater on this fireplace is protected with a safety device to prevent overheating.

Should the heater overheat, a red light (Fig. 1) will be activated and an automatic cutout

will turn the heater off and it will not come back on without being reset. It can be reset by

switching the Main Power switch to OFF and waiting 5 minutes before switching it to ON.

The overheat cutout will be triggered if the filter is dirty. Follow filter maintenance on page 7.

CAUTION

If the heater continuously resets, disconnect the power at the main service panel and call

your local dealer.

NOTE

The heater may emit a slight, harmless odor when first used. This odor is a normal

condition caused by initial heating of internal heater parts and will not occur again.

Maintenance

WARNING

Disconnect all power coming to fireplace at main service panel before attempting

maintenance or cleaning to reduce risk of fire, shock or damage to persons.

NOTE

Allow at least 5 minutes for light bulbs to cool off before touching bulbs to avoid accidental

burning of skin.

Tool Requirements

Phillips screwdriver

Allow at least 5 minutes for light bulbs to cool off before touching bulbs to avoid accidental

burning of skin.

Light bulbs need to be replaced when you notice a dark section of the flame or when the

clarity and detail of the log exterior disappears. There are four bulbs under the log set

which generate the flames and embers.

Light Bulb Requirements

Quantity of 4 clear chandelier or candelabra bulbs with an E-12 (small) socket base, 60

watt rating. Example: GE 60BC or Philips 60CTC.

DO NOT EXCEED 60 WATTS PER BULB.

CAUTION

When handling log only apply force to the ember bed section not directly to the logs.

Helpful Hints

It is a good idea to replace all light bulbs at one time if they are close to the end of their

rated life. Group replacement will reduce the number of times you need to open the unit to

replace light bulbs. Long life bulbs are recommended to reduce the frequency of bulb

changes.