Toshiba 13340 설치 매뉴얼 - 페이지 13

{카테고리_이름} Toshiba 13340에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Toshiba 13340 18 페이지.

페이지 인쇄

Outdoor Unit

CAUTION

• Incorrect/incomplete wiring will cause

electrical ﬁ res or smoke.

• Prepare the power source for exclusive

use with the air conditioner.

• This product can be connected to the

main power.

Fixed wire connections:

A switch that disconnects all poles and

has a contact separation of at least

3 mm must be incorporated into the ﬁ xed

wiring.

Wire Connection

• The dash lines show on-site wiring.

(Main circuit)

Input power

Leakage

breaker

Earth

• Connect the indoor/outdoor connecting cables to the identical terminal

numbers on the terminal block of each unit.

• Incorrect connection may cause a failure.

Model

RAS-2M10U2AVG-E

Power supply

Maximum running

12.3A

current

Installation fuse

rating

Power cord

Connecting cable

1. Remove the valve cover screws.

2. Pull the valve cover in the direction of arrow, and remove it.

3. Remove the cord clamp and the terminal cover.

(System

interconnection wires)

Remote

controller

Indoor unit

RAS-2M14U2AVG-E

RAS-3M18U2AVG-E

RAS-2M18U2AVG-E

1ph, 50Hz, 220-240V

12.6A

13.1A

15A

(All types can be used)

H07RN-F or 60245 IEC 66

3-core 1.5 mm²

H07RN-F or 60245 IEC 66

4-core 1.0 mm²

Valve cover

Terminal cover

Cord clamp

4. Connect the wires for the power source and each indoor unit.

• Connect the connecting cable to the terminal as identiﬁ ed by the

matching numbers on the terminal block of the indoor and the outdoor

unit.

5. Fix the wiring connections for the power source and each indoor unit

securely using a cord clamp.

6. Attach the terminal cover and the valve cover.

Stripping Length of connecting cable for outdoor unit

1 2 3

Earth wire

Connecting cable

Earth screw

Connecting cable

Unit A

Earth screw

Connecting cable

Unit B

Grounding

This air conditioner must be grounded without fail.

• Grounding is necessary not only to safeguard against the possibility

of receiving an electric shock but also to absorb both static, which is

generated by high frequencies and held in the surface of the outdoor unit,

and noise since the air conditioner incorporates a frequency conversion

device (called an inverter) in the outdoor unit.

• If the air conditioner is not grounded, users may receive an electric shock

if they touch the surface of the outdoor unit and that unit is charged with

static.

Test run

Wiring/Piping Check

CAUTION

Electric current is applied on the

control board. Beware of electric

shock.

1. Remove the valve cover screws.

2. Pull the valve cover in the direction of arrow, and remove it.

Installation Manual

L N

Power cord

Earth screw

Power cord

Earth screw

Connecting cable

Unit C

Valve cover

LED

Service switches

D801

D803

D805

SW02

D800

D802

D804

SW01

Earth wire