Toshiba 13PKCVG-V 소유자 매뉴얼 - 페이지 3

{카테고리_이름} Toshiba 13PKCVG-V에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Toshiba 13PKCVG-V 8 페이지.

페이지 인쇄

ONE-TOUCH

Press the "ONE-TOUCH" button for fully automated operation that is

customized to the typical consumer preferences in your region of the world.

The customized settings control temperature air ﬂ ow strength, air ﬂ ow

direction and other settings to provide you alternate contact with "ONE-

TOUCH" of the button. If you prefer other settings you can select from the

many other operating functions of your Toshiba unit.

ONE-TOUCH

Press

: Start the operation.

AUTOMATIC OPERATION

To automatically select cooling or fan only operation

MODE

1. Press

: Select A.

2. Press

: Set the desired temperature.

FAN

3. Press

: Select AUTO, LOW , LOW+

MED+

, or HIGH

COOLING / FAN ONLY OPERATION

MODE

1. Press

: Select Cool

or Fan only

2. Press

: Set the desired temperature.

Cooling: Min. 17°C, Fan Only: No temperature indication

FAN

3. Press

: Select AUTO, LOW , LOW+

MED+

, or HIGH

DRY OPERATION

For dehumidiﬁ cation, a moderate cooling performance is controlled automatically.

MODE

1. Press

: Select Dry

2. Press

: Set the desired temperature.

Hi-POWER OPERATION

To automatically control room temperature and airﬂ ow for faster cooling

operation (except in DRY and FAN ONLY mode)

Hi POWER

Press

: Start and stop the operation.

POWER-SELECTION OPERATION

This function is used when its circuit breaker is shared with other electrical

appliances. It limits the maximum current/power consumption to 100%, 75%

or 50%. The lower the percentage, the higher the saving and also the longer

the compressor lifetime.

POWER-SEL

Press

: Select

(for 100%),

●

When the level is selected, PWR-SEL level ﬂashes on LCD display for 3

seconds. In case of 75% and 50% level, number "75" or "50" also ﬂashes

for 2 seconds.

●

Due to the reason that POWER SELECT FUNCTION limits the maximum

current, inadequate cooling capacity may occur.

TEMPORARY OPERATION

In case of the misplaced or discharged remote control

●

Pressing the RESET button, the unit can start or

stop without using the remote control.

●

Operation mode is set on AUTOMATIC operation,

preset temperature is 24°C and fan operation is

automatic speed.

TIMER OPERATION

Set the timer when the air conditioner is operating.

Daily timer allows the user to set both the ON & OFF timers and will be

activated on a daily basis.

Setting Daily Timer

, MED

●

During the daily timer is activating, both arrows ( , ) are indicated.

Note:

●

Keep the remote control in accessible transmission to the indoor unit;

otherwise, the time lag of up to 15 minutes will occur.

●

The setting will be saved for the next same operation.

PRESET OPERATION

Set your preferred operation for future use. The setting will be memorized by

the unit for future operation (except airﬂ ow direction).

, MED

1. Select your preferred operation.

2. Press and hold

The P mark displays.

3. Press

AUTO RESTART OPERATION

To automatically restart the air conditioner after the power failure (Power of

the unit must be on.)

Setting

1. Press and hold the RESET button on the indoor unit for 3 seconds to set

the operation. (3 beep sound and OPERATION lamp blink 5 time/sec for

5 seconds)

2. Press and hold the RESET button on the indoor unit for 3 seconds to

cancel the operation. (3 beep sound but OPERATION lamp does not

blink)

●

QUIET OPERATION

To operate at super low fan speed for quiet operation (except in DRY mode)

Press

Note: Under certain conditions, QUIET operation may not provide adequate

(for 75%),

(for 50%)

COMFORT SLEEP OPERATION

For comfortable sleep, automatically control air ﬂ ow and automatically turn OFF.

Press

Note: The cooling operation, the set temperature will increase automatically

MAINTENANCE

Firstly, turn off the circuit breaker.

Indoor Unit and Remote Control

●

Clean the indoor unit and the remote control with a wet cloth when needed.

●

No benzine, thinner, polishing powder or chemically-treated duster.

Air ﬁ lters

Clean every 2 weeks.

1. Open the air inlet grille.

2. Remove the air ﬁ lter.

3. Vacuum or wash and then dry them.

4. Reinstall the air ﬁ lters and close the air inlet grille.

Setting the ON Timer

Setting the OFF Timer

Press

: Set the desired

ON timer.

Press

: Set the timer.

Press

: Cancel the timer.

Press

: Set the ON timer.

Press

: Set the OFF timer.

the ( or ) mark ﬂ ashing.

for 3 seconds to memorize the setting.

: Operate the preset operation.

In case of ON timer or OFF timer are set, AUTO RESTART OPERATION

does not activate.

QUIET

: Start and stop the operation.

cooling due to low sound features.

: Select 1, 3, 5 or 9 hrs for OFF timer operation.

1 degree/hour for 2 hours (maximum 2 degrees increase).

: Set the desired

OFF timer.

: Set the timer.

: Cancel the timer.

button during