Dimplex BF33STP 설치 매뉴얼 - 페이지 11

{카테고리_이름} Dimplex BF33STP에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dimplex BF33STP 14 페이지. Fireplace
Dimplex BF33STP에 대해서도 마찬가지입니다: 실용적인 사용자 설명서 (15 페이지), 소유자 매뉴얼 (14 페이지), 서비스 매뉴얼 (20 페이지), 사용자 설명서 (14 페이지), 문제 해결 매뉴얼 (2 페이지), 소유자 매뉴얼 (14 페이지)

Dimplex BF33STP 설치 매뉴얼

120V/240V HEATER WALL SWITCH CONTROL

!
NOTE: Before installing the unit complete the following:
1.
Install main power connection with appropriate wiring - directly to the main power or through a wall switch.
2.
Install a 2 conductor wire with ground (3 wires total) from the heater switch wall box to the junction box on the
unit.
!
NOTE: Use a heater wall switch (On/Off) that is rated for a minimum of 15 amps.
1.
Loosen the screw securing the junction box cover and remove the cover.
2.
Remove the knockouts (if necessary) or use the provided cable clamp.
3.
Pull out the three wires marked 1, 2, and G (red, red, and green).
4.
Remove the wire connector and separate the wires marked 1 and 2.
5.
Connect the 1 wire (red) from the unit to the L1 wire (black) from the heater wall switch by using a wire connector (not
supplied).
6.
Connect the other end of L1 wire (black) from the heater wall switch to the L1 terminal of the heater wall switch.
7.
Connect the 2 wire (red) from the unit to the Neutral wire (white) from the heater wall switch using a wire connector (not
supplied).
8.
Connect the other end of the Neutral wire (white) from the heater wall switch to the L2 terminal of the heater wall switch.
9.
Connect the Ground wire (green) from the unit to the Ground wire (green) from the heater wall switch using a wire con-
nector (not supplied).
10.
Secure the remaining Ground wire (green) with a ground screw in the heater switch wall box.
11.
Ensure that all connections are tight.
12.
Insert all the wiring of the heater wall switch into the heater switch wall box.
13.
Insert all the wiring back into the unit and secure with a cable clamp.
RED – 2
RED – 1
GROUND - G
1
2
G
2
1
G
WALL
SWITCH
G FROM UNIT
G FROM
POWER SUPPLY
G FROM UNIT
L1 FROM UNIT
WIRE 2 FROM
UNIT
NEUTRAL FROM
UNIT AND SUPPLY
L1 FROM
POWER SUPPLY
WIRE 1 FROM
2 CONDUCTOR WIRE
FROM HEATER SWITCH
!
NOTE: This only illustrates
heater switch connection,
see previous sections for
main power connection
instructions.
UNIT
11