Toshiba Carrier MMD-AP0184SPH2UL 설치 매뉴얼 - 페이지 9
{카테고리_이름} Toshiba Carrier MMD-AP0184SPH2UL에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Toshiba Carrier MMD-AP0184SPH2UL 44 페이지. Air conditioner multi type
페이지 인쇄Connecting drain pipe
Insert flexible drain hose into upper drain pipe of main unit as far as it will go. Fix it with hose band.
REQUIREMENT
Mount the flexible drain hose using the hose band without using adhesive.
Hose band
Indoor unit
0.6
15 mm) or less
" (
Drain up (condensate pumped up from unit)
When gravity drainage cannot be provided directly from the indoor unit condensate exit the piping can be arranged
for upward condensate discharge. The vertical leg of the drain line must be a maximum of 15.8"(400 mm) or less
from the indoor condensate exit and the total vertical height of the leg must be a maximum of 33.5"(850 mm) or
less before the drain enters a gravity flow line. These dimensions are specified by the indoor unit condensate pump
limitations. As specified for the gravity flow installation all materials and suspension methods must comply with
applicable codes and regulations.
Indoor unit
15-EN
Flexible
drain hose
400 mm)
15.8"(
or less
Underside of ceiling
Check the condensate drain system
When all piping and wiring is completed the condensate drain system (including the pump) should be checked for
correct operation and leaks. If there are any abnormal sounds, leaks, or if the condensate water does not flow
normally, the problem should be diagnosed and corrected before the system is certified for operation.
In the test run, check that water drain is properly performed and water does not leak from the connecting part of
the pipes. When doing this, also check that no abnormal sounds are heard from the drain pump motor. Check
draining also when installed in heating period.
When the electrical and wiring work has been completed
Pour some water by following the method shown in the following figure. Then, while performing a cooling operation,
check that the water drains from the drain pipe connecting port (transparent) and that no water is leaking from the
drain pipe.
When the electrical and wiring work has not been completed
• Disconnect the float switch connector (3P: Red) from the connector (CN34: Red) on the printed circuit board
inside the electrical control box. (Before doing this, the power must be turned off.)
• Connect a 208 / 230 V supply voltage to (L1) and (L2) on the power supply terminal block. (Do not apply a 208
/ 230 V voltage to (A), (B) of the terminal block. Otherwise, the printed circuit board may be damaged.)
• Pour the water by following the method shown in the following figure. (Amount of water poured: 0.4 to 0.5 gal
(1500 to 2000 cc))
• When the power is turned on, the drain pump automatically starts running. Check whether the water is draining
from the drain pipe connecting port, and check that no water is leaking from the drain pipe.
• After checking that the water drains and there are no water leaks, turn off the power, connect the float switch
connector to its original location (CN34) on the printed circuit board, and return the electrical control box to its
original position.
208 / 230-1-60
White
Red
Black
Black
Pull out connector CN34 (Red)
from P.C. board.
– 8 –
Insert the edge of hose into the
drain pan and bend it downward.
Cover plate
Pump
Vessel
Water
(0.4 to 0.5 gal
(1500 to 2000 cc))
EN
16-EN