Dimplex BF36DX 서비스 매뉴얼 - 페이지 11

{카테고리_이름} Dimplex BF36DX에 대한 서비스 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dimplex BF36DX 13 페이지. Optiflame electric fireplace
Dimplex BF36DX에 대해서도 마찬가지입니다: 설치 매뉴얼 (10 페이지)

페이지 인쇄

ate wire to meet local and national electrical codes for rated

power consumption.

For 240 volt installations a three conductor, non-metallic

sheath cable with ground wire is recommended for the

incoming power supply on fireplace inserts. Use the appropri-

ate wire to meet local and national electrical codes for rated

power consumption.

REWIRE UNIT FROM 208/240 VOLT TO 120

VOLT WITH REMOTE CONTROLS

NOTE: Rewiring the unit from 208/240 volt to 120 volt

configuration must be completed prior to installing the unit.

1. Loosen the screw securing the junction box cover and

remove the cover.

2. Remove the knockouts (if necessary) or use the provided

cable clamp.

3. Pull all of the wiring connections out of the fireplace junc-

tion box and reconfigure the labeled wires using the chart

below.

MODELS WITH REMOTE CONTROLS:

208/240V (from factory)

L1, L1, 1

3, 5

L2, 6

B, C, 7

F, F, F

When the conversion is completed following the above chart

there will be four wires remaining. A red wire that is not used

and must have a wire nut installed, a black (L1) wire, a white

(neutral) wire, and a green (ground) wire.

Connect the black (L1) wire from the unit to the (L1) wire

from the power supply. Connect the white (neutral) wire to

the (neutral) wire from the power supply. Connect the green

(ground) wire to the (ground) wire from the power supply.

4. Once the wiring has been configured for the proper sup-

ply voltage replace wire bundle inside the unit leaving the

connection lines and/or thermostat connections available

for supply power connection.

REWIRE UNIT FROM 208/240 VOLT TO 120

VOLT WITHOUT REMOTE CONTROLS

configuration must be completed prior to installing the unit.

1. Loosen the screw securing the junction box cover and

2. Remove the knockouts (if necessary) or use the provided

3. Pull all of the wiring connections out of the fireplace junc-

MODELS WITHOUT REMOTE CONTROLS:

When the conversion is completed following the chart above

120V

there should be two wires remaining. A black (L1) wire and

L1, L1, 1

green (ground) wire. Connect the black (L1) wire from the

F, F, F, 6

unit to the (L1) wire from the power supply. Connect the

green (ground) wire to the (ground) wire from the power sup-

7, 8

ply. Connect the neutral wire from the power supply to the

B, 3

wiring connection with wires marked F & L2.

C, 5, L2

4. Once the wiring has been configured for the proper sup-

NOTE: Rewiring the unit from 208/240 volt to 120 volt

remove the cover.

cable clamp.

tion box and reconfigure the labeled wires using the chart

below.

208/240V (from factory)

5, 6

1, 2

3, 4

ply voltage replace wire bundle inside the unit leaving the

connection lines and/or thermostat connections available

for supply power connection.

120V

2, 3

1, 4

F, L

5, 6