3Com SuperStackII Switch 9300 빠른 설치 매뉴얼 - 페이지 4

{카테고리_이름} 3Com SuperStackII Switch 9300에 대한 빠른 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. 3Com SuperStackII Switch 9300 12 페이지.

Quick Installation Guide

Install Modules

(Switch 3900 only)

Attach the

Cables

Power Up

the System

If you have ordered one or two additional Gigabit Ethernet modules for

your SuperStack II Switch 3900 system, you are now ready to install the

modules.

CAUTION: Electrostatic discharge (ESD) can damage components on a

module, causing complete or intermittent failures. ESD damage occurs

when the module is improperly handled. When handling modules, be

sure to read and follow the ESD safety information provided in the

Module Installation Guide.

For installation instructions, see the 1000BASE-SX/1000BASE-LX Gigabit

Ethernet Module Installation Guide that is shipped with the module.

Cable your system for connecting these elements to your network:

10/100BASE-T connectors (3900 only)

1000BASE-SX or LX connectors (3900 and 9300)

10BASE-T out-of-band port connector (9300 only)

Console port (3900 and 9300)

For information on cabling ports, see Chapter 3 in the Getting Started

Guide for your system.

Place the system near an easily accessible power outlet because the only

way that you can power the system up or down is to insert or remove the

power cord from the power source. To get your system powered up and

ready to operate:

1 For the Switch 3900, verify that each unused slot is covered with a blank

faceplate.

To view possible error messages in the Administration Console while the

system is running power-up diagnostics, connect a terminal, workstation,

or PC with terminal emulation software to the system's Console port.

2 On the back panel of either the Switch 3900 or the Switch 9300, plug the

power cord into the power receptacle.

CAUTION: To prevent a possible fire hazard, be sure to fully insert the

power cord.

3 Plug the other end of the power cord into a power outlet.