Dimplex BF39DXP 설치 매뉴얼 - 페이지 5

{카테고리_이름} Dimplex BF39DXP에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dimplex BF39DXP 14 페이지. Fireplace
Dimplex BF39DXP에 대해서도 마찬가지입니다: 실용적인 사용자 설명서 (15 페이지), 소유자 매뉴얼 (14 페이지), 서비스 매뉴얼 (20 페이지), 사용자 설명서 (14 페이지), 문제 해결 매뉴얼 (2 페이지), 소유자 매뉴얼 (14 페이지)

SECTION B: GENERAL ELECTRICAL INFORMATION

For 120V installations use two conductor, non-metallic sheath cable with ground wire (3 wires total) for the incoming power

supply on fireplace inserts. Use the appropriate wire to meet local and national electrical codes for rated power consumption.

For 208V / 240V installations use three conductor, non-metallic sheath cable with ground wire (4 wires total) for the incom-

ing power supply on fireplace inserts. Use the appropriate wire to meet local and national electrical codes for rated power

consumption.

Two conductor, non-metallic sheath cable with ground wire (3 wires total) is recommended for installation of a wall mounted

thermostat and/or wall switch for use on fireplace inserts. Use appropriate wire to meet local and national electrical codes for

rated power consumption. All wire gauges should match the recommended wire sizes shown below.

IMPORTANT: Ensure that the incoming power supply voltage matches the setting of the voltage selector switch.

NOTE: The voltage selector switch is located inside the exhaust panel on the top right hand corner.

CAUTION: When changing the voltage selector switch from 240V to 120V ensure that the power supply is turned off.

NOTE: Carefully insert a flat headed screwdriver inside the exhaust panel to change the switch from 240V (230 position)

to 120V (115 position).

When wiring the unit for 208V / 240V the voltage selector switch should be in the 230V position.

When wiring the unit for 120V the voltage selector switch should be in the 115V position.

Voltage

Wire Gauge

120 Volts

12 Gauge

208 Volts

12 Gauge

240 Volts

12 Gauge

Fuse Rating

15 Amp