Dimplex BF39STP 설치 매뉴얼 - 페이지 7
{카테고리_이름} Dimplex BF39STP에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dimplex BF39STP 14 페이지. Fireplace
Dimplex BF39STP에 대해서도 마찬가지입니다: 실용적인 사용자 설명서 (15 페이지), 소유자 매뉴얼 (14 페이지), 서비스 매뉴얼 (20 페이지), 사용자 설명서 (14 페이지), 문제 해결 매뉴얼 (2 페이지), 소유자 매뉴얼 (14 페이지)
페이지 인쇄
3.
Remove the knockouts (if necessary) or use the provided cable clamp.
4.
Pull out the four wires marked L1, L2, N, and G.
5.
Connect L1 (black) wire from the unit to the L1 (black) from the power supply.
6.
Connect L2 (red) and N (white) from the unit to the Neutral (white) from the power supply.
7.
Connect the ground wire (green) from the unit to the ground from the power supply.
8.
When the unit has been configured for the appropriate power supply voltage, ensure that all connections are tight.
9.
Insert all the wiring back into the unit and secure with a cable clamp.
120V INSTALLATION - NO HEAT INSTALLATION
!
IMPORTANT: The unit is factory configured for 208/240V operation.
!
NOTE: Use 2 conductor wires with ground (3 wires total) from the power supply (breaker panel) to the junction box on the
unit.
!
NOTE: All wiring must be completed prior to installing the unit.
!
NOTE: Ensure that the voltage selector switch is in the proper position for the required supply voltage prior to connecting
the unit to the power supply.
!
NOTE: PurifireTM will operate without heat in this application.
1.
Locate the voltage selector switch inside the exhaust panel on the top right hand corner of the unit.
240V to 120V configuration. (230 and 115 is printed on switch)
2.
Loosen the screw securing the junction box cover and remove the cover.
3.
Remove the knockouts (if necessary) or use the provided cable clamp.
4.
Pull out the four wires marked L1, L2, N, and G.
5.
Connect L1 (black) wire from the unit to the L1 (black) from the power supply.
6.
Connect L2 (red) and N (white) from the unit to the Neutral (white) from the power supply.
7.
Connect the ground wire (green) from the unit to the ground from the power supply.
8.
Locate and separate, by installing a wire nut on the 1 (red) and 2 (red).
9.
When the unit has been configured for the appropriate power supply voltage, ensure that all connections are tight.
10.
Insert all the wiring back into the unit and secure with a cable clamp.
WHITE WIRE - N
RED WIRE – L2
BLACK WIRE – L1
GREEN WIRE - G
RED - 1
WIRE NUTS
RED - 2
WHITE WIRE - N
POWER
BLACK WIRE – L1
SUPPLY
GROUND WIRE - G
(BREAKER
PANEL)
120 V
Flip the switch from
7