Dimplex BF8000ST 소유자 매뉴얼 - 페이지 7

{카테고리_이름} Dimplex BF8000ST에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dimplex BF8000ST 16 페이지. 26” self trimming fireplace
Dimplex BF8000ST에 대해서도 마찬가지입니다: 소유자 매뉴얼 (17 페이지), 서비스 매뉴얼 (16 페이지)

페이지 인쇄

2. Remove the foam block from within the fireplace (Figure 2).

3. Using side cutters or scissors, cut and remove the two (2) cable

ties as shown in Figure 2 and remove the cardboard that protects

the log set.

4. Remove the right hand side trim by removing four (4) Phillips

screws at the side of the fireplace.

5. Place the Front Glass onto the track of the fireplace (Figure 3) and

slide it along the front until it reaches the far left of the unit.

6. Re-attach the right hand trim piece using the four (4) Philips screws

from step 4.

Figure 2

Cable

Ties

Site Selection and Preparation

This section provides instructions for selecting a location and preparing

the site to install the fireplace into your Dimplex mantel surround.

1. Select a suitable location that is not susceptible to moisture and is

away from drapes, furniture and high traffic.

2. For ease of electrical hook up you may wish to locate the fireplace

near an existing outlet (refer to NOTE 1).

3. Store the fireplace in a safe dry and dust free location.

CAUTION: Clearance for air circulation beneath the fireplace is

provided by two spacers. Do not install fireplace directly on

Figure 3

Foam

block

Track

Front

Glass

Trim